manuale per l'installatore - 1/3 tipologie d'installazione - 2/3 software ...

By clicking on ADVANCED key
in the section concerning injectors
and other components, it is possible
to display the injector characteristics.
It is possible you have to
read them to BRC technical
Assistance service in case of problems.
A similar section could be
activated from the main
screen, outside the aided procedure,
by selecting Setting up -->
Type of Installation.
4.2.1.3 Temperature sensors
Calibration (only for CNG)
It is the third step of the aided
procedure in case of a CNG equipment;
it is not displayed in case of
a LPG one (see picture 4.1) and it
is useful to calibrate the temperature
sensor of the engine cooling
water so that it can be read and
used by the ECU.
Choose sensor enabled if the
original cooling water temperature
sensor of the petrol engine has
been connected (picture 4.5).
By choosing this second option
it is necessary to calibrate the sensor.
To do it the vehicle has to be
cold.
If not it is possible, choose the
option sensor Disabled in this section
and calibrate it later, out of the
aided procedure, through the suitable
option from the Setting up
menu.
To calibrate the sensor follow
this procedure:
1. Select Sensor Enabled (see
picture 4.6).
2. Click on Calibration key.
Pic. 4.4d - Aided Procedure – injectors and installation calibration by clicking on
ADVANCED key in the injectors section
Pic. 4.5 - Aided procedure – Temperature sensors calibration
Pic. 4.6 - Aided procedure – Temperature sensors calibration – first value acquisition
18