LIBRARY ı6ıul 0) - Cranfield University

offset2:
"WPARAMS":
distance between the edge end point and the weld end point,
measured along the edge towards its mid-point
header for the sublist containing the selected welding parameters
S: predicted welding speed
V: predicted power source set-up voltage
WFS: predicted wire feed speed
leg_pred: predicted leg length
[transfer mode]: predicted transfer mode according to expected power ratio:
"UNSTABLE", "DIP", "GLOBULAR" or "SPRAY"
Table A. 1- Welding extended entity data list
(_3
List item Description
flag indicating that XDATA follows
(°°CRANWELD" start welding extended entity data using
"CRANWELD" as the registered application
(1002. "1")
(1000. "WSETUP")
(1000. (car GASWIRE))
(1000. (caddr GASWIRE))
(1002. ")")
(1002. "(")
(1000. "WGEOM")
(1070. wnum)
(1000 . jtype)
(1040. leg/pen)
(1040. A0)
(1040. SO)
(1040. pthick)
(1040. gap)
(1070. pos)
(1000. wpos)
1002 ."
name
start sublist WSETUP
header for the sublist containing the welding
setup
filename containing the models' coefficients
description of shielding gas and wire
end sublist WSETUP
start sublist "WGEOM"
header for the sublist containing weld
geometry
16 bit integer containig the weld number
string ("FILLET' or "LAP" or `BUTT")
real - leg length (pen=penetration for butt
joints)
real - tolerance for the leg length or
penetration
real - stand-off
real - minimum plate thickness
real - gap size
16 bit integer - positional(I) or non-
positional(0)
string - welding position "flat", "horizontal",
`vertical", "overhead"
close sublist "WGEOM"
225