View/Open

More documents

Recommendations

Info

h fg Latent heat of evaporation J / kg h Specific enthalpy of a gaseous mixture J / kg h i h va Specific enthalpy of individual component in a gaseous mixture xxiv J / kg Thermal enthalpy brought in by evaporated water vapour J / kg H Height of a surface m H Increased enthalpy gained by air flowing through the blower J / kg k Thermal conductivity W / ( m K) k Al k C kma k w k ev kevn kevf k ec lCB lC1i L D L T lTl Thermal conductivity of Aluminium W / ( m K) Chamber wall material thermal conductivity (High-density polyethylene) W / ( m K) Thermal conductivity of moist air W / ( m K) Water thermal conductivity W / ( m K) Water surface mass convection (evaporation) coefficient m/s Natural mass convection (evaporation) coefficients m/s Forced mass convection (evaporation) coefficients m/s condensation-to-evaporation coefficient Decimal Thickness of the Chamber base m Wall 1 height (water height level) m Connecting duct length m HADT length m HADT lump length m m Mass kg m C1 Mass of chamber wall 1 kg
m C 23 m Ca m cv m Cw m store m i m Ma m MW m Mec mMecN mMecP m Tlec mTlecN mTlecP m Tl m Tla M a m C Mass of wall 2 and 3 together kg Average air mass in chamber kg Fluid mass of a controlled volume kg Mass of water in humidifier chamber kg Air mass in a container kg Mass of individual component in the mixture kg Mass of air in the mask kg Mass of mask wall kg Net condensation or evaporation within a breath cycle in the mask Total amount of condensation occurred within a breath cycle in the mask (the negative part of m Mec ) Total amount of evaporation or evaporation potentiality within a breath cycle in the mask (the positive part of m Mec ) Net condensation or evaporation within a breath cycle in an HADT lump Total amount of condensation occurred within a breath cycle in an HADT lump(the negative part of m Tlec ) Total amount of evaporation or evaporation potentiality within a breath cycle in an HADT lump (the positive part of m Tlec ) Mass of one lump HADT wall kg Air mass in one HADT lump kg Molar mass of air kg Mass flow rate in chamber kg/s xxv kg kg kg kg kg kg
Page 1 and 2: The Effects of CPAP Tube Reverse Fl
Page 3 and 4: Acknowledgement First of all, I wou
Page 5 and 6: When deep breathing induced reverse
Page 7 and 8: 2.4.1 Reverse flow calculation ....
Page 9 and 10: 5.3.1 Thermal dynamic model under s
Page 11 and 12: XI.3 Steady state mask thermal bala
Page 13 and 14: List of Figures Figure 1.1 Obstruct
Page 15 and 16: Figure 5.10 Comparison between expe
Page 17 and 18: Figure 6.13 Fluctuation of airflow
Page 19 and 20: Table 5.3 Comparison of condensatio
Page 21 and 22: Nomenclature Symbol Meaning of the
Page 23: CMFeO CMFet C O C t Concentration o
Page 27 and 28: Nu Cp Nu dir Nu Ti Nu To Nuwsn Nuws
Page 29 and 30: QMor QMwst QTastn QTicn QTin Q
Page 31 and 32: R Mic R Moc R Ticn R Toc R Torn Mas
Page 33 and 34: V Capacity of the container m 3 V C
Page 35 and 36: 1.1 Background Chapter 1 Introducti
Page 37 and 38: The MRD is worn in user’s mouth w
Page 39 and 40: Figure 1.4 CPAP machine Figure 1.5
Page 41 and 42: 1.3 Literature survey A literature
Page 43 and 44: CPAP fluid dynamic performance with
Page 45 and 46: Chapter 2 Mathematical Modelling of
Page 47 and 48: 2.3 Fluid dynamic analysis This sec
Page 49 and 50: If there are minor pressure drops,
Page 51 and 52: Figure 2.6 Pressure sensor - Honeyw
Page 53 and 54: The pressure readings were taken af
Page 55 and 56: Figure 2.12 Experimental set up for
Page 57 and 58: 2.3.4 Chamber air space mass balanc
Page 59 and 60: From the above analysis, the pressu
Page 61 and 62: Figure 2.18 Full face mask and the
Page 63 and 64: Inserting Eq. (2.26) and Eq. (2.27)
Page 65 and 66: Where n( ) t is the airflow proper
Page 67 and 68: However in reality, mixing turns ou
Page 69 and 70: Chapter 3 Mathematical Modelling of
Page 71 and 72: An Environment Control Chamber (Vö
Page 73 and 74: Figure 3.4 Thermal enthalpy gain of
Page 75 and 76:
Figure 3.6 Heating element beneath
Page 77 and 78:
Figure 3.8 Chamber water heat balan
Page 79 and 80:
Table 3.1 Thermal resistance from h
Page 81 and 82:
3.3.1.2 Heat balance at the outer s
Page 83 and 84:
3.3.2 Heat flow from chamber water
Page 85 and 86:
through ADU which is a function of
Page 87 and 88:
It is assumed that the direct impac
Page 89 and 90:
Sc a a (3.47) Dwa Analogous to th
Page 91 and 92:
and keep them in gaseous status. On
Page 93 and 94:
through the walls and natural conve
Page 95 and 96:
Where d Ca is the specific humidity
Page 97 and 98:
TTa ( n1) is also considered as inl
Page 99 and 100:
R Torn 2 2 ATlor ( TTWn T )( TTWn
Page 101 and 102:
condensation severity but cannot ca
Page 103 and 104:
condensation has occurred at all or
Page 105 and 106:
The inlet is the air from HADT duri
Page 107 and 108:
3.9 Average temperature of inhaled
Page 109 and 110:
Table 4.1 Inputs to the fluid dynam
Page 111 and 112:
Figure 4.2 Simulink TM model for fl
Page 113 and 114:
Table 4.4 Outputs from the overall
Page 115 and 116:
Gain block after input 1 is to conv
Page 117 and 118:
Figure 4.7 Varying Transport Delay
Page 119 and 120:
4.2.5 Mask mixing calculation subsy
Page 121 and 122:
4.3 Computational model of thermal
Page 123 and 124:
Figure 4.11 Block diagram of CPAP t
Page 125 and 126:
Figure 4.13 Simulink TM model for t
Page 127 and 128:
The outputs are listed in Table 4.1
Page 129 and 130:
Page 131 and 132:
Figure 4.16 Dynamic chamber-air the
Page 133 and 134:
Figure 4.17 HADT lump thermal balan
Page 135 and 136:
Figure 4.18 Steady state HADT lump
Page 137 and 138:
Figure 4.19 HADT lump air dynamic f
Page 139 and 140:
Page 141 and 142:
Figure 4.21Steady state mask full t
Page 143 and 144:
4 Temperature of airflow from HADT
Page 145 and 146:
Average evaporation rate subsystem
Page 147 and 148:
HADT and connects those upstream se
Page 149 and 150:
The experiment was also carried out
Page 151 and 152:
air flowing through the elbow, a ce
Page 153 and 154:
expansion from the elbow to the mas
Page 155 and 156:
Figure 5.12 Environmental control r
Page 157 and 158:
Table 5.1 shows the combinations of
Page 159 and 160:
Figure 5.17 Comparison of model out
Page 161 and 162:
The comparison of experimental resu
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
5.3.1.4 Airflow temperature at the
Page 169 and 170:
flow rate had been even further inc
Page 171 and 172:
Figure 5.31 Comparison of condensat
Page 173 and 174:
Table 5.3 Comparison of condensatio
Page 175 and 176:
3. The corrugated grooves on the HA
Page 177 and 178:
5.3.2.1 Validation of evaporation r
Page 179 and 180:
The experiment observation showed t
Page 181 and 182:
Figure 6.1 Reverse flow under diffe
Page 183 and 184:
It can also be seen in Figure 6.2 t
Page 185 and 186:
within the same period. However, wh
Page 187 and 188:
Figure 6.6 Comparison of evaporatio
Page 189 and 190:
Figure 6.8 Airflow velocity in HADT
Page 191 and 192:
Figure 6.11 Airflow velocity in HAD
Page 193 and 194:
In Figure 6.14 the blue curve repre
Page 195 and 196:
6.3.3.1.2 Comparison when heating e
Page 197 and 198:
This vaporization potentiality (coi
Page 199 and 200:
Figure 6.20 In-tube condensation of
Page 201 and 202:
When using different sized masks, t
Page 203 and 204:
Figure 6.23 Average specific humidi
Page 205 and 206:
The average specific humidity in an
Page 207 and 208:
Table 6.5 Comparison of average spe
Page 209 and 210:
6. The deep breathing and reverse f
Page 211 and 212:
Appendices Appendix I Regression of
Page 213 and 214:
Appendix I. Regression of the press
Page 215 and 216:
Figure I. 1 Tested results and the
Page 217 and 218:
Appendix II. Regression of the pres
Page 219 and 220:
Table III. 2 Airflow temperature an
Page 221 and 222:
Appendix IV. The corrugated HADT ou
Page 223 and 224:
The total area of the complicated c
Page 225 and 226:
Figure V. 1 Regression of saturated
Page 227 and 228:
This ratio can be regressed against
Page 229 and 230:
Appendix VII. Details of the CPAP f
Page 231 and 232:
VII.4 The mask pressure subsystem F
Page 233 and 234:
Inputs to this water-centred subsys
Page 235 and 236:
Input port number Input Unit 1 Heat
Page 237 and 238:
input 4 is the portion of impact ar
Page 239 and 240:
VIII.2.3 Water surface mass transfe
Page 241 and 242:
This subsystem also contains two su
Page 243 and 244:
VIII.2.5 Chamber wall 1 heat transf
Page 245 and 246:
Figure VIII. 13 Wall 1 outer surfac
Page 247 and 248:
Wall 2 and 3 inner surface temperat
Page 249 and 250:
Figure VIII. 17 Chamber wall 2 and
Page 251 and 252:
Inputs to this subsystem are listed
Page 253 and 254:
Appendix IX. Details of steady stat
Page 255 and 256:
Figure IX. 3 The HADT lump wall out
Page 257 and 258:
Appendix X. Details of HADT lump ai
Page 259 and 260:
2 Absolute value of airflow velocit
Page 261 and 262:
Figure X. 5 HADT lump inlet absolut
Page 263 and 264:
Figure XI. 2 Steady state mask mixi
Page 265 and 266:
Figure XI. 4 Steady state mask wall
Page 267 and 268:
Input port number Input Unit 1 Aver
Page 269 and 270:
Appendix XII. Details of mask air d
Page 271 and 272:
4 Length of the triangular plate in
Page 273 and 274:
8 Length of the triangular plate in
Page 275 and 276:
Appendix XIII. Details of the auxil
Page 277 and 278:
XIII.3 Breath load average subsyste
Page 279 and 280:
Figure XIII. 7 Average evaporation
Page 281 and 282:
XIV.1.2 Under normal ambient temper
Page 283 and 284:
XIV.2.3 Under high ambient temperat
Page 285 and 286:
XIV.4 Airflow temperature at the en
Page 287 and 288:
XIV.5.2 Under normal ambient temper
Page 289 and 290:
XIV.6.3 Under high ambient temperat
Page 291 and 292:
Appendix XVI. Regression of kinetic
Page 293 and 294:
Figure XVII. 2 Condensation/evapora
Page 295 and 296:
Figure XVIII. 2 Condensation/evapor
Page 297 and 298:
at point C. Right after that, here
Page 299 and 300:
Appendix XIX. Coefficient and param
Page 301 and 302:
Average water thermal conductivity
Page 303 and 304:
Appendix XXI. Fluid dynamic and the
Page 305 and 306:
The lung simulator drives the air.
Page 307 and 308:
Appendix XXII. Model user instructi
Page 309 and 310:
The input blocks and their values a
Page 311 and 312:
Dynamically fluctuating air tempera
Page 313 and 314:
References [1] Good sleep advice. W
Page 315 and 316:
[28] Schettino GPP, Chatmongkolchar
Page 317:
[60] Marek R, Straub J. Analysis of
show all

View/Open

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?