Problem Determination and Service Guide - Public Support Login ...

Removing and replacing server components
1. Make sure that all internal cables are correctly routed.
2. Align the top-cover bracket on top of the server so that the metal tabs line up correctly
on the chassis, and then rotate it into place.
3. Slide the blue latches on the top cover bracket toward the outside of the server to lock
it in place.
Removing the front bezel
Note: You do not have to remove the top cover before you remove the bezel.
To remove the bezel, complete the following steps:
1. Read the safety information in Section 1 and Installation guidelines.
2. Press on the bezel retention tabs at the sides of the bezel, and pull the bezel from the
server.
3. If you are instructed to return the bezel, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing the front bezel
To install the bezel, align the studs with the matching holes on all four corners; then, push
in and snap the bezel into place.
6–10 3850 7281–000