Problem Determination and Service Guide - Public Support Login ...

Removing and replacing server components
11. Turn on all attached devices and the server.
12. Restore the RAID configuration information that you backed up before you removed
the I/O-board shuttle.
Removing the DVD cable
To remove the DVD cable, complete the following steps:
1. Read the safety information in Section 1 and Installation guidelines.
2. Turn off the server and peripheral devices, and disconnect the power cords and all
external cables as necessary to replace the device.
3. Remove the front bezel (see Removing the front bezel ).
4. Push in the release button on the DVD drive and pull the drive out of the server.
5. Remove the top cover (see Removing the top cover ).
6. Remove the top cover bracket (see Removing the top-cover bracket ).
7. Remove the middle fan (see Removing the middle hot-swap fan ).
8. Disconnect the SAS cables and remove the ServeRAID card from the dedicated PCI
connector (see Removing the RAID adapter carrier and the RAID adapter assembly).
9. Remove the memory cards and memory card fillers (see Removing a memory card ).
10. Remove the memory cage (see Removing the memory-card cage).
11. Disconnect the cable from the rear of the DVD housing.
12. Disconnect the cables from the I/O board.
6–42 3850 7281–000