Problem Determination and Service Guide - Public Support Login ...

Removing and replacing server components
3. Disconnect the power cord from the connector on the back of the power supply.
4. Slide the orange release latch on the handle to the right and lift the handle up to the
open position.
5. Pull the power supply out of the bay.
6. If you are instructed to return the hot-swap power supply, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to you.
Replacing the hot-swap power supply
To install the replacement hot-swap power supply, complete the following steps:
1. Touch the static-protective package that contains the power supply to any unpainted
surface on the outside of the server; then, remove it from the package.
2. Press the orange release latch on the handle to the right and pull the handle up to the
open position if it is not already in the open position.
3. Push the power supply into the bay, slide the latch to the right, and push the handle
down to lock it.
4. Connect one end of the power cord for the new power supply into the AC inlet on the
back of the power supply, and connect the other end of the power cord into a properly
grounded electrical outlet.
5. Route the cable through the retention hook on the back of the power supply.
6. If the server is turned off, turn on the server.
7. Make sure that the AC and DC power LED on the power supply is lit, indicating that
the power supply is operating correctly.
6–24 3850 7281–000