Job Instruction Manual - Training Within Industry Service

Steps in the Operation "Key Points"
2. Make R. H. loop in Cross in front of main
right hand wire (Wire strand (Fig. 2).
- old wirk at j unc-
tionof Yoopandmain
st rand.
remaining wire (Wire
4. Put end of wire "A"
through first loop.
(Fig. 3)
Pass under stub pro-
truding to left.
Behind main strand.
5. Pull taut.
- Take wire ends ("A"
and "B") in finger
and thumb of right
hand and hold
stranded wire at Ends even (Fig. 4).
- Use thumb and first
finger of left hand
to make loops lie
neatly and snugly
across the main
strand, and to ad-
just the knot to ap-
proximately 6 inches
from the ends of the Knot snug.
wires.