Download - Fuji Xerox Printers
Download - Fuji Xerox Printers
Download - Fuji Xerox Printers
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Corrupt HD file<br />
Press Set key<br />
Message<br />
Condition/Reason/Action<br />
When the hard disk (optional) is installed, the printer assumes that data in the hard<br />
disk is corrupted if power is cut off when the printer is in use.<br />
Press the button on the control panel. The hard disk will be initialized.<br />
Important<br />
• Initializing the hard disk will delete data for registered forms, logos and secure<br />
print. If the PostScript software kit (optional) is installed, PostScript download fonts<br />
will also be deleted.<br />
Corrupt Log file<br />
Press Set key<br />
When the hard disk (optional) is installed, the printer assumes that data in the hard<br />
disk is corrupted if power is cut off when the printer is in use.<br />
Press the button on the control panel. The log file will be initialized.<br />
Important<br />
• It takes several tens of seconds to initialize the log file. Do not switch off the power<br />
of this printer when initialization is in progress.<br />
Ejecting...<br />
xxxx Tray *<br />
Empty Center<br />
Output Tray<br />
Ended with Error<br />
xxx-xxx<br />
The printer is forcedly outputting the remaining print data. The printer cannot receive<br />
any print data from the computer during processing.<br />
The center output tray is full. Remove paper from the center output tray.<br />
An error has occurred and printing does not finish successfully.<br />
Check the error code “xxx-xxx” displayed in the screen and perform the appropriate<br />
procedures.<br />
Refer to<br />
• “List of Error Codes” (P. 115)<br />
Incorrect paper<br />
type Reselect<br />
Set to Print<br />
Stop to Cancel<br />
Initializing<br />
PostScript<br />
Load Tray *<br />
xxxx XXXX<br />
Paper of the type specified under [Specify Paper Type] in the printer driver is not<br />
loaded in the trays. Press the button on the control panel to print on<br />
paper of another type or press the button to cancel the job.<br />
This is displayed when the PostScript software kit (optional) is installed and indicates<br />
that the printer system is being initialized. This is displayed when the power is<br />
switched on or the system is reset.<br />
There is no paper whose size and orientation is “xxxx” and whose paper type is<br />
“XXXX” left in the tray.<br />
Load paper whose size and orientation is “xxxx” and whose paper type is “XXXX”<br />
into the tray * .<br />
Refer to<br />
• “Loading Paper in a Paper Tray” (P. 59)<br />
Lower Rear<br />
OutputTray lever<br />
Off-line<br />
Off-line<br />
Data in memory<br />
Open Cover A or B<br />
Clear Jam<br />
Since the rear tray is specified as the output destination, the printer cannot output to<br />
the center output tray. Push down the rear output tray lever and change the output<br />
destination to the center output tray.<br />
The printer is offline as the button has been pressed. To cancel the offline<br />
status, press the button again.<br />
Note<br />
• The printer cannot receive any print data from the computer while it is offline.<br />
Paper jam has occurred around the printer fuser unit.<br />
Open cover A or B of the printer to remove the jammed paper.<br />
Refer to<br />
• “5.1 When Paper Jams” (P. 101)<br />
112 5 Troubleshooting
Change language