Download - Fuji Xerox Printers
Download - Fuji Xerox Printers
Download - Fuji Xerox Printers
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
•TBCP Filter<br />
Specifies whether to enable or disable the TBCP filter when processing PostScript data.<br />
This item is displayed only when the PostScript software kit (optional) is installed. The<br />
default is [Disable].<br />
UPnP<br />
Makes settings fpr UPnP (Universal Plug and Play).<br />
•Port Status<br />
Specifies whether to enable or disable the UPnP when the printer turns on. The default is<br />
[Disable].<br />
Important<br />
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this<br />
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate<br />
Memory].<br />
SNMP<br />
Configure these settings to use SNMP. SNMP settings are required to use the application<br />
that remotely controls multiple printers. The printer information is maintained in SNMP. The<br />
application obtains the printer information from the SNMP.<br />
•Port Status<br />
Specifies whether to enable or disable the SNMP port when the printer turns on. The default<br />
is [Enable], which means the SNMP port is available.<br />
Important<br />
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this<br />
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate<br />
Memory].<br />
•Transpt Protocol<br />
Specifies the transport protocol used for SNMP. IPX, UDP, or both protocols can be<br />
specified. The default is [UDP].<br />
Note<br />
• When using UDP, both the IP addresses of a computer and the printer are required.<br />
• Refer to the application’s manual for the protocol to be used: IPX or UDP.<br />
* No.1 to 3 characters of 4 are available (refer to P. 95)<br />
•Community (R)<br />
Specify the community name used for reading the printer management information (MIB)<br />
with up to 12 alphanumeric characters. The default is [Unregistered].<br />
* No.1 to 3 characters of 4 are available (refer to P. 95)<br />
•Community (R/W)<br />
Specify the community name used for reading/writing the printer management information<br />
(MIB) with up to 12 alphanumeric characters. The default is [Unregistered].<br />
* No.1 to 3 characters of 4 are available (refer to P. 95)<br />
•Community (Trap)<br />
Specify the community name used for trapping with up to 12 alphanumeric characters. The<br />
default is [Unregistered].<br />
84 4 Settings on the Control Panel