Download - Fuji Xerox Printers
Download - Fuji Xerox Printers
Download - Fuji Xerox Printers
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
*3 (refer to P. 95)<br />
•Auto Eject Time<br />
Sets the time interval for the printer to automatically print the remaining data when no further<br />
data is received for a continuous period.<br />
The time can be set between 5 to 1275 seconds in increments of 5 seconds. The default is<br />
[30 Secs]. When no data is received for the period specified here after the last data was<br />
received, the printer determines it as job end.<br />
•Baud rate<br />
Sets the baud rate. Select from [9600bps] [19200bps] [38400bps] [57600bps] [115200bps]<br />
[4800bps]. The default is [9600bps].<br />
•Stop Bit<br />
Select the stop bit from [1 bit] or [2 bits]. The default is [1 bit].<br />
•Parity<br />
Sets the parity. Select from [Not Available] [Odd] [Even]. The default is [Not Available].<br />
•XON - XOFF Control<br />
Sets whether to enable or disable the XON/XOFF control at the flow control. The default is<br />
[On].<br />
•DTR Control<br />
Sets the DTR control from [Fix-High] [Fix-Low] [Active-High] [Active-Low]. The default is<br />
[Fix-High].<br />
LPD<br />
Select this to use LPD.<br />
•Port Status<br />
Specifies whether to enable or disable the LPD port when the printer turns on. The default<br />
is [Enable], which means the LPD port is available.<br />
Note<br />
• To enable the LPD port, the IP address must be specified.<br />
Important<br />
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this<br />
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate<br />
Memory].<br />
•Print Mode *1 (refer to P. 95)<br />
Specifies the print data process method (printer language to be used).<br />
[Auto] (default)<br />
Select this to make the printer automatically detect the printer language being used in the<br />
data received from a computer and perform printing based on the detected data.<br />
[PCL] [PS] [HP-GL/2] [TIFF]<br />
Select this to process the data received from a computer as the specified data type. [PS] is<br />
displayed when the PostScript software kit (optional) is installed.<br />
•PJL*2 (refer to P. 95)<br />
This printer supports PJL commands that are independent from any printer languages. The<br />
PJL commands are used to control print jobs and are required for printing using a printer<br />
driver. In this menu, specify whether to enable or disable the PJL commands sent from a<br />
computer. PJL commands allow you to specify the printer language to be used for the next<br />
data even while the printer is using a different printer language at the time. Normally, it<br />
should be set to [Enable]. The default is [Enable].<br />
78 4 Settings on the Control Panel
Change language