Download - Fuji Xerox Printers

DefaultPaperSize
Specifies the default setting of the paper size when using E-mail Printing feature, the paper
size when printing the reports, and the [Output Size] setting of the each print mode to [A4]
or [8.5×11"]. This default is [A4].
Allocate Memory
*3 (refer to P. 95)
[Allocate Memory] menu is used to change the capacity of the memory for each interface
and the form memory.
In this printer, you can change the following memory allocation. Note that the allocated
memory type differs depending on the installation status of optional accessories.
PS memory
HPGL auto layout memory
Receive buffer size
Print page buffer
: Available
: Not available
: Not available when the hard disk (optional) is installed.
PS: PostScript software kit (optional)
Important
• Changing the memory capacity will reset the memory and delete all data stored in each memory area.
• You cannot exceed the overall memory capacity during memory allocation. If the setting value exceeds
the actual memory capacity, the system will automatically adjust it when the printer turns on.
• If the memory is running out when [Enable] is specified for the port, the port may be disabled
automatically. In this case, you need to disable the port(s) you are not using or change the memory
allocation. However, the parallel and USB ports will not stop automatically.
Note
• The memory allocation settings (except the print page buffer setting) are available in the control panel
and CentreWare Internet Services.
• The print page buffer is the area in which the actual print image can be drawn. The print page buffer is
allocated to the remaining area after the memory is allocated to all other uses. Therefore, you cannot
directly change the print page buffer capacity. You can check the actual print page buffer size in [System
Settings List]. You can also check it in CentreWare Internet Services. When you want to print a
high-resolution document, allocate memory so that the print page buffer size is large.
PS
Specifies the memory capacity for PostScript (optional). This item is displayed when the
PostScript software kit (optional) is installed.
Specify the memory capacity between 4.50 and 96.00 MB in increments of 0.25 MB. The
default is [12.00 M]. The maximum capacity you can specify depends on the free memory
capacity.
HPGL Auto Layout
Memory types Standard PS
Specifies the memory capacity used for HP-GL, HP-GL/2 auto layout.
Specify the memory capacity between 64 and 5120 KB in increments of 32 KB. The default
is [64K]. The maximum capacity you can specify depends on the free memory capacity.
If the hard disk (optional) is installed, the hard disk memory is used for the auto layout. You
cannot change its capacity. [Hard Disk] is displayed on the screen.
92 4 Settings on the Control Panel