Download - Fuji Xerox Printers

2.4 Printing on Custom Size Paper/Long Paper
This section explains how to print on custom size paper such as long paper.
The paper sizes that can be selected on this printer are as follows:
• For tray 1 • For trays 2 - 4 • For bypass tray
Long edge:
98 to 900 mm
Long edge:
148 to 432 mm
Long edge:
98 to 900 mm
Short edge:
76 to 305 mm
* To load long-size paper with the long
edge exceeding 432 mm, load the
paper with the edge protruding from
the tray.
Short edge:
76 to 297 mm
Short edge:
76 to 305 mm
Loading Custom Size Paper
Loading Custom Size Paper in a Paper Tray
The way to load custom size paper with the long edge shorter than 432 mm in trays 1 to 4
is the same as loading standard size paper. For details, refer to “3.2 Loading Paper” (P. 59).
To load long paper in tray 1, follow the procedure below:
1. Pull the paper tray to its maximum.
Note
• Pull the extendable part out to its maximum (A3 size).
For details on the procedure to extend the paper tray,
refer to “3.2 Loading Paper” (P. 59).
2. Load the paper with the side to be printed
facing up. Curl up the back end of the paper
so that it will not fall from the tray.
3. Push the paper tray completely into the printer.
Important
• Do not close the lid of the paper tray.
2.4 Printing on Custom Size Paper/Long Paper 27