12.02.2014 Views

Download - Fuji Xerox Printers

Download - Fuji Xerox Printers

Download - Fuji Xerox Printers

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Ethernet<br />

Specifies the communication speed/connector type of the Ethernet interface.<br />

[Auto] (default)<br />

Select this to switch between 100BASE-TX and 10BASE-T automatically.<br />

[100BASE-TX]<br />

Select this to use 100BASE-TX only.<br />

[10BASE-T]<br />

Select this to use 10BASE-T only.<br />

IPX/SPX Frame Type<br />

Specifies the operational frame type of IPX/SPX.<br />

[Auto] (default)<br />

Select this to automatically configure the frame type.<br />

[Ethernet II]<br />

Select this to use the Ethernet frame type.<br />

[Ethernet 802.3]<br />

Select this to use the IEEE802.3 frame type.<br />

[Ethernet 802.2]<br />

Select this to use the IEEE802.3/IEEE802.2 frame type.<br />

[Ethernet SNAP]<br />

Select this to use the IEEE802.3/IEEE802.2/SNAP frame type.<br />

Filter<br />

•IP Filter<br />

Specifies whether to limit IP addresses that receive print jobs. Select [On] if you do not want<br />

to receive print jobs from non-registered IP addresses. The default is [Off].<br />

Note<br />

• Even if [On] is selected, it becomes invalid when all the registered IP addresses are “000.000.000.000”.<br />

•IP Address *3 (refer to P. 95)<br />

Registers the IP addresses that are allowed to receive jobs if you want to limit the IP<br />

addresses. You can specify up to 10 IP addresses. Specify the address masks for the<br />

registered IP addresses. Enter the IP addresses and address masks in the format of<br />

xxx.xxx.xxx.xxx. You can set values between 0 and 255 for xxx. For example, if you specify<br />

“126.249.110.23” in [IP address] and “255.255.255.0” in [IP Address Mask], the addresses<br />

that are allowed to receive jobs are “129.249.110.* (1 to 254)”.<br />

System Settings<br />

[System Settings] menu is used to make the printer operation settings such as for alarm and<br />

power saver mode.<br />

Alert Tone<br />

Specifies whether to turn on the alarm when an error occurs in the printer. The default is<br />

[Off]. You cannot adjust the sound volume.<br />

86 4 Settings on the Control Panel

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!