Download - Fuji Xerox Printers

•Adobe Protocol
Specifies the communications protocol for PostScript. This item is displayed only when the
PostScript software kit (optional) is installed.
[Normal] (default)
Select this when the communication protocol is in ASCII format.
[Binary]
Select this when the communication protocol is in binary format. Selecting this may cause
the printing process to be faster than [Normal] depending on the printing data.
[TBCP]
Select this when you have to switch between ASCII and binary formats by using specific
control codes because they are both used as the communication protocol.
Note
• Select an option according to the data format output from the printer driver in a computer.
• Generally, accept the default setting, [Normal].
• This setting is only available when PostScript is used for printing.
Port9100
Select this to use Port9100.
•Port Status
Specifies whether to enable or disable the Port9100 port when the printer turns on. The
default is [Enable], which means the Port9100 port is available.
Note
• To enable the Port9100 port, the IP address must be set.
Important
• If the memory is running out when the port is enabled, the port may be disabled automatically. In this
case, you need to disable the port(s) you are not using or change the memory allocation from [Allocate
Memory].
•Print Mode *1 (refer to P. 95)
Sets the print data process method (printer language to be used).
[Auto] (default)
Select this to make the printer automatically detect the printer language being used in the
data received from a computer and perform printing based on the detected data.
[PCL] [PS] [HP-GL/2] [TIFF]
Select this to process the data received from a computer as the specified data type. [PS] is
displayed only when the PostScript software kit (optional) is installed.
•PJL*2 (refer to P. 95)
This printer supports PJL commands that are independent from any printer languages. The
PJL commands are used to control print jobs and are required for printing using a printer
driver. In this menu, specify whether to enable or disable the PJL commands sent from a
computer. PJL commands allow you to specify the printer language to be used for the next
data even while the printer is using a different printer language at the time. Normally, select
[Enable] for this setting. The default is [Enable].
•Connect Time-Out *3 (refer to P. 95)
Specifies the interval for disconnection when no further data is received. You can specify a
value between 2 and 65535 seconds in increments of 1 second. The default is [60 Secs].
•Port No.
Sets the port number to 9100 or a value between 8000 and 9999. The default is [9100].
4.2 Description of Menu Items 83