Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Synchronous</strong> <strong>Generators</strong> <strong>BG</strong> <strong>132</strong> / <strong>BG</strong> <strong>160</strong><br />
Chapter 4: 4.5 Installation for single-bearing generators<br />
4.5.4 Installation to the engine (single-bearing generators)<br />
The minimum clearances <strong>and</strong> regulations for cooling given in the section above<br />
have to be met for installation.<br />
4.5.4.1 Sealing of the generator against the engine<br />
During installation a sealing has to be attached between the generator <strong>and</strong> the<br />
engine. The type of sealing depends on the used engine. The sealings prescribed<br />
for the different engines are listed in the following table.<br />
Engine Type of sealing Installation instructions<br />
B&S 12.5 HP / 14 HP VE1/877 or VE1/977 Press the sealing into the<br />
shaft opening in the end<br />
shield.<br />
Honda GX 390 K1V VE1/871 Bond the sealing into the<br />
Yamaha MZ 360 K<br />
corresponding clearance in the<br />
end shield.<br />
Yanmar L90 / L100 Fluid sealing Apply liquid sealant into the<br />
corresponding clearance in the<br />
end shield.<br />
Hatz 1D 60C<br />
No sealing required.<br />
Issue date: August 2002 37
Change language