Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Synchronous</strong> <strong>Generators</strong> <strong>BG</strong> <strong>132</strong> / <strong>BG</strong> <strong>160</strong><br />
Chapter 8, Removal<br />
8 Removal<br />
To remove the generator, proceed according to the descriptions given in this<br />
chapter.<br />
8.1 Safety precautions<br />
DANGER<br />
Removing of the generator may only be performed by<br />
authorized <strong>and</strong> qualified personnel.<br />
Generator components may be very hot, not just during but also<br />
after operation. Burning hazard!<br />
For removing the generator make sure that the switched-off<br />
engine cannot be restarted accidentally (e.g. by removing the<br />
ignition key <strong>and</strong> keeping it safe). Mortal danger by electric<br />
shock, risk of personal injury!<br />
8.2 Removal of two-bearing generators (<strong>BG</strong><strong>132</strong> <strong>and</strong> <strong>BG</strong><strong>160</strong>)<br />
The removal of two-bearing generators has to be performed in accordance with<br />
the descriptions in chapter 4.<br />
8.3 Removal of single-bearing generators<br />
NOTE<br />
For the removal of single-bearing generators the following special<br />
tools are required:<br />
• Special tool of the engine manufacturer to hold the engine<br />
shaft.<br />
• For shaft fastening by grub-screw:<br />
Special hexagon nut for turning the generator shaft using a<br />
spanner as well as special sawing ring pliers for removing <strong>and</strong><br />
mounting the sawing ring which secures the fan impeller on the<br />
shaft.<br />
• For shaft fastening by tension bolt:<br />
Pushing rod <strong>and</strong> pushing screw.<br />
• Additionally for brush-type generators:<br />
Special wooden chock serving as transport locking for the rotor.<br />
Issue date: August 2002 93