Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Synchronous</strong> <strong>Generators</strong> <strong>BG</strong> <strong>132</strong> / <strong>BG</strong> <strong>160</strong><br />
Chapter 4: 4.6 Installation of two-bearing generators (<strong>BG</strong> <strong>132</strong>)<br />
4.6.5.2 Hydraulic drive for <strong>BG</strong> <strong>132</strong> with reinforced end shield<br />
Removal prior to installation<br />
At the generator perform the removal prior to installation as described on page<br />
56 (see Figure 18).<br />
Installation<br />
1. Set the flange (Figure 21/1) onto the generator <strong>and</strong> fasten it using the four<br />
screws (2a). Underlay the screws with a blocking disk (2b) <strong>and</strong> apply<br />
threadlocking adhesive to the thread of the screws.<br />
2. Plug the first part of the clutch (3) onto the generator shaft <strong>and</strong> protect it<br />
against twisting on the shaft by means of a feathered key.<br />
3. Mount the disc (4) to the hydraulic motor (6).<br />
4. Set the second part of the clutch (3) onto the hydraulic motor.<br />
5. Set the hydraulic motor (6) together with the disc (4) <strong>and</strong> the second part of<br />
the clutch onto the generator. When inserting, twist the clutch a little bit<br />
until the gearing locks, if necessary.<br />
6. Underlay the eight screws (5a) with a blocking disc (5b) <strong>and</strong> use them to<br />
fasten the disc (4) to the flange (1).<br />
7. Place the sleeve (7) to the clutch assembly <strong>and</strong> fasten it by tightening the<br />
two screws.<br />
60 Issue date: August 2002