Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Synchronous</strong> <strong>Generators</strong> <strong>BG</strong> <strong>132</strong> / <strong>BG</strong> <strong>160</strong><br />
Chapter 4: 4.6 Installation of two-bearing generators (<strong>BG</strong> <strong>132</strong>)<br />
4.6.3 Installation instructions for belt drive (two-bearing<br />
types, <strong>BG</strong> <strong>132</strong>)<br />
Belt pulleys <strong>and</strong> belts must be covered by a<br />
<br />
protective cover. Never operate the generator<br />
without the protective covers correctly<br />
mounted. Risk of personal injury!<br />
DANGER<br />
Never touch a running belt. Risk of personal<br />
injury!<br />
Do not knock the belt pulley onto the shaft.<br />
Taper bushes must be preferred for fastening.<br />
CAUTION<br />
To prevent the belt pulley against twisting,<br />
it is protected on the shaft by a feathered<br />
key. The belt pulley is fastened by a screw to<br />
the front end of the shaft. This screw has to<br />
be protected against accidental loosening<br />
using a suitable lock washer.<br />
• Threaded hole in the shaft:<br />
M10 x 22 mm<br />
• Tightening torque: M = 50 Nm<br />
The axis of the driving shaft must be<br />
absolutely parallel to the shaft of the<br />
generator.<br />
The belt pulleys on both shafts must be<br />
flush to each other so that the belt runs<br />
absolutely straight.<br />
52 Issue date: August 2002