Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Synchronous</strong> <strong>Generators</strong> <strong>BG</strong> <strong>132</strong> / <strong>BG</strong> <strong>160</strong><br />
Chapter 4: 4.6 Installation of two-bearing generators (<strong>BG</strong> <strong>132</strong>)<br />
Installation<br />
1. Set the flange (Figure 17/1) onto the generator <strong>and</strong> fasten it using the four<br />
screws (4a) with nuts (3a). Underlay the screw head with a blocking disk<br />
(4b) <strong>and</strong> apply threadlocking adhesive to the thread of the screw. Underlay<br />
the nuts with toothed disks (3b).<br />
2. Remount the sleeve (Figure 17/2) <strong>and</strong> fasten it by tightening the two screws.<br />
3. Plug the clutch-plate (5) onto the generator shaft <strong>and</strong> protect it against<br />
twisting on the shaft by means of a feathered key.<br />
4. Fasten the driving side of the clutch (6) to the engine <strong>and</strong> insert it into the<br />
clutch-plate. When inserting, twist the clutch a little bit until the gearing<br />
locks, if necessary.<br />
5. Fasten the flange (1) to the engine.<br />
1<br />
4x<br />
6<br />
5<br />
4a<br />
4b<br />
2<br />
3b<br />
3a<br />
4x<br />
Figure 17 Installation for flange mounting (two-bearing types, <strong>BG</strong> <strong>132</strong><br />
with st<strong>and</strong>ard end shield)<br />
Issue date: August 2002 55
Change language