Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Synchronous</strong> <strong>Generators</strong> <strong>BG</strong> <strong>132</strong> / <strong>BG</strong> <strong>160</strong><br />
Chapter 4: 4.6 Installation of two-bearing generators (<strong>BG</strong> <strong>132</strong>)<br />
The belt must not sag loosely.<br />
When using slim SPA-type V-belts, the<br />
distance between the shafts must not<br />
exceed 600 mm. Permissible shaft distances<br />
for other belts can be obtained from the<br />
manufacturer.<br />
Maximum tractive force (tension) of the<br />
drive belt on the shaft:<br />
• F max = 2000 N for st<strong>and</strong>ard end shield<br />
(shaft ø28mm)<br />
• F max = 3800 N for reinforced end shield<br />
(shaftø32mm)<br />
The specified maximum tractive force is<br />
applicable at an axial distance of max. 50<br />
mm from the shaft outlet in the end shield.<br />
If the belt is to be mounted with a greater<br />
distance to the end shield, the belt tension<br />
must be reduced in order to compensate the<br />
higher leverage to the shaft.<br />
Type <strong>and</strong> number of used belts<br />
The type <strong>and</strong> number of used belts have to<br />
be adapted to the power of the generator.<br />
The maximum belt tension force has to be<br />
observed!<br />
F max<br />
l max<br />
Issue date: August 2002 53
Change language