Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
Synchronous Generators BG 132 and BG 160
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Synchronous</strong> <strong>Generators</strong> <strong>BG</strong> <strong>132</strong> / <strong>BG</strong> <strong>160</strong><br />
Chapter 4: 4.7 Installation of two-bearing generators (<strong>BG</strong> <strong>160</strong>)<br />
Installation<br />
1. Set the flange (Figure 23/1) onto the generator <strong>and</strong> fasten it using the four<br />
screws (2a). Underlay the screw head with a toothed disk (2b) <strong>and</strong> apply<br />
threadlocking adhesive to the thread of the screw.<br />
2. Plug the clutch-plate (3) onto the generator shaft <strong>and</strong> protect it against<br />
twisting on the shaft by means of a feathered key.<br />
3. Fasten the driving side of the clutch (4) to the engine <strong>and</strong> insert it into the<br />
clutch-plate. When inserting, twist the clutch a little bit until the gearing<br />
locks, if necessary.<br />
4. Fasten the flange (1) to the engine.<br />
1<br />
4x<br />
4<br />
3<br />
2a<br />
2b<br />
Figure 23 Installation of the flange mounting (<strong>BG</strong> <strong>160</strong>)<br />
Issue date: August 2002 67
Change language