Experimental and Numerical Analysis of a PCM-Supported ...

More documents

Recommendations

Info

Figure 6.2: Evolution of inlet and outlet liquid and gas temperatures for PCM packing height 78cm; Top: evaporator, (b) Bottom condenser 133
Figure 6.3: Evolution of solid phase temperatures for PCM packing height 78cm; Top: Evaporator, Bottom: Condenser 134
Page 1:
Technische Universität München In
Page 4 and 5:
It is my pleasure to thank Prof. Th
Page 6 and 7:
Contents List of figures ..........
Page 8 and 9:
5.3 Functional description ........
Page 10 and 11:
List of Figures Figure 1.1: Cost br
Page 12 and 13:
78cm; Top: Evaporator, Bottom: Cond
Page 14 and 15:
xii
Page 16 and 17:
m Mass flow rate; [kg.s -1 ] m eva
Page 18 and 19:
ed c coll cond cw d d e or eff evap
Page 20 and 21:
1 Introduction The first part of th
Page 22 and 23:
summarized in figure (1.2). Thermal
Page 24 and 25:
1.3.2 Selection criteria of desalin
Page 26 and 27:
of energy storage or hybridization
Page 28 and 29:
Desalination development focuses on
Page 30 and 31:
Introduction of the indirect type s
Page 32 and 33:
2 Literature Survey 2.1 Introductio
Page 34 and 35:
There is actually a commercial prod
Page 36 and 37:
Q m H c ( T T1) c ( T 2 T ) (2.2)
Page 38 and 39:
(solid-liquid) have a storage densi
Page 40 and 41:
(iii) a sharp melting temperature.
Page 42 and 43:
melt and freeze without segregation
Page 44 and 45:
However, the stored heat is less va
Page 46 and 47:
parameters on the heat transfer and
Page 48 and 49:
categories. The first category is b
Page 50 and 51:
to 550 kWh/m 3 of distilled water a
Page 52 and 53:
The enthalpy and humidity of the sa
Page 54 and 55:
Air mass flow rate [kg/h] GOR [-] 1
Page 56 and 57:
On the other hand, the efficiency o
Page 58 and 59:
2.8.4.2 Effect of air to water mass
Page 60 and 61:
distillate rate. The system was not
Page 62 and 63:
were; EnviPac Gr.1, 32 mm, and VFF
Page 64 and 65:
Figure 2.15: Height versus air temp
Page 66 and 67:
The performance of the condenser is
Page 68 and 69:
Klausner and Mei [136] described a
Page 70 and 71:
The impact of the collector cost ca
Page 72 and 73:
exchanger and energy storage in one
Page 74 and 75:
3 Scope of the Study This chapter p
Page 76 and 77:
packing where it gets in direct con
Page 78 and 79:
In fact there is a tradeoff between
Page 80 and 81:
The energy flow between all and eac
Page 82 and 83:
4 Theoretical Analysis and Modeling
Page 84 and 85:
The two-energy equation models whic
Page 86 and 87:
solid-liquid phase change inside th
Page 88 and 89:
assumed by conduction in both axial
Page 90 and 91:
the air pressure drop ∆P per unit
Page 92 and 93:
evaporation rate per unit volume of
Page 94 and 95:
where β t , β c , ρ ref , c ref
Page 96 and 97:
the viscous transport and introduce
Page 98 and 99:
liquid and solid phases, respective
Page 100 and 101:
4.2.3.3 Liquid and gas hold-ups Liq
Page 102 and 103: Several models and approaches for m
Page 104 and 105: where G=ρU d /ε g is the pore mas
Page 106 and 107: k k eff s 1 3 2 (4.55) This cor
Page 108 and 109: uncertainties associated with the f
Page 110 and 111: 1 2 (4.62) d1 capp c2 c1 c2 1
Page 112 and 113: [58] evaluated the cooling tower ai
Page 114 and 115: 1 exp NTU 1 C r, cond cond (4
Page 116 and 117: A HE QHE U T HE LM (4.81) Where Q
Page 118 and 119: c M f b (4.86) M b S S f where r
Page 120 and 121: that form the study logical foundat
Page 122 and 123: 5 Experimental Analysis This chapte
Page 124 and 125: 5.2 Measuring Techniques K-type the
Page 126 and 127: The product condensed water was mea
Page 128 and 129: operating limits. In light of the l
Page 130 and 131: In the last two cases, the inlet ho
Page 132 and 133: performance and its threshold value
Page 134 and 135: It could be interpreted that this p
Page 136 and 137: Evaporator Condenser Figure 5.8: Av
Page 138 and 139: within the inaccuracy margins. The
Page 140 and 141: The last two cases of boundary cond
Page 142 and 143: natural air flow in the system. In
Page 144 and 145: 6 Model Implementation and Validati
Page 146 and 147: x t u x u 0 0 , (6.5) and for a s
Page 148 and 149: Next time step validation were the
Page 150 and 151: The evaporator and condenser both w
Page 154 and 155: Figure 6.4: Evolution of inlet and
Page 156 and 157: temperature is at its maximum level
Page 158 and 159: Bottom Top Figure 6.7: Evolution of
Page 160 and 161: 7 Parameters Analysis of the Evapor
Page 162 and 163: Figure 7.1: Effect of packing size
Page 164 and 165: e 0.45 kPa under natural convection
Page 166 and 167: aspect ratio under constant bed vol
Page 168 and 169: Figure 7.7: Effect of inlet hot wat
Page 170 and 171: well as the time required to reach
Page 172 and 173: Figure 7.10: Effect of packing medi
Page 174 and 175: 40°C respectively. This gives flex
Page 176 and 177: the condensate rate, productivity f
Page 178 and 179: esult, rather than PCM media which
Page 180 and 181: Figure 7.18: Effect of PCM thermal
Page 182 and 183: 8 Optimization of HDH plant In this
Page 184 and 185: The MATLAB model describes how the
Page 186 and 187: less steep than that of the distill
Page 188 and 189: 8.3.4 Effect of hot water flow rate
Page 190 and 191: storage materials and thus it can h
Page 192 and 193: for latent heat storage would be ob
Page 194 and 195: When T m becomes sufficiently highe
Page 196 and 197: 9 Summary and conclusions 9.1 Summa
Page 198 and 199: productivities at any cooling water
Page 200 and 201: [13] Vafai K., Sozen M. An investig
Page 202 and 203:
[48] Crone S., Bergins C., and Stra
Page 204 and 205:
[79] Tiwari G.N. and Yadav Y.P. (78
Page 206 and 207:
[109] Mehling H., Hiebler S. and Zi
Page 208 and 209:
[139] Belessiotis V, Delyannis E (2
Page 210 and 211:
Appendices Appendix A A1. PCM Therm
Page 212 and 213:
A3. Constants and Thermo-physical p
Page 214 and 215:
From the above correlation, the con
Page 216 and 217:
The Ergun analogy factor J h repres
Page 218 and 219:
Equation (C.7) represents an overal
Page 220 and 221:
Appendix D D1. Cooling tower theory
Page 222 and 223:
A m w = the plan or cross sectiona
show all

Experimental and Numerical Analysis of a PCM-Supported ...

Create successful ePaper yourself

Delete template?

Save as template?