Experimental and Numerical Analysis of a PCM-Supported ...

More documents

Recommendations

Info

[139] Belessiotis V, Delyannis E (2001). Water shortage and renewable energies (RE) desalination-possible technological applications. Desalination 139: 133- 138. [140] Haddad O.M., Al-Nimr M.A. and Maqableh A. (2000). Enhanced solar still performance using a radiative cooling system. Renewable Energy 21: 459- 469. [141] Miyatake O., Koito Y., Tagawa K. and Maruta Y. (2001). Transient characteristics and performance of a novel desalination system based on heat storage and spray flashing. Desalination 137: 157–166. [142] Al-Enezi G., Ettouney H. and Fawzy N. (2006). Low temperature humidification dehumidification process. Energy Conversion and Management 47: 470-484. [143] Lex M.F., Sattelmayer T., Spinnler M. and Blumenberg J. (2003). Solar thermal distillation evaporation over a packed bed. Diploma Thesis, Lehrstuhl für Thermodynamik, Technische Universität München. [144] Gahin S., Darwish M.A. and Ghazi M.A. (1980). Solar powered humidificationdehumidification desalination system. Proceedings of the 7 th International symposium on Fresh Water from the Sea, Athenes, Greece, 1980: 399-406. [145] Abdel Moneim M.A. (1989). Theoritical and experimental studies of a humidification-dehumidification desalination system. Ph.D. Thesis, Faculty of Engineering, Cairo University, Egypt. [146] Kheder M.M (1988). Desalination by air humidification. Ph.D. Thesis, Faculty of Engineering, Cairo University, Egypt. [147] Swift A.H.P, Huanmin, L. and Becerra H. (2002). Zero discharge waste brine management for for desalination plants. Desalination Research and Development Program Report No. 89, Final Report, University of Texas at El Paso El Paso, Texas. [148] Dawoud, B., Zurigat, Y.H., Klitzing, B., Aldoss, T. and Theodoridis, G. (2006). On the possible techniques to cool the condenser of seawater greenhouses. Desalination 195(1-3): 119-140. [149] Narayan G. Prakash, Sharqawy M. H., Summers E. K., Lienhard J. H., Zubair S. M., Antar M.A., (2010). The potential of solar-driven humidificationdehumidification desalination for small-scale decentralized water production. Renewable and Sustainable Energy Reviews 14(4): 1187-1201. [150] Galen E. V. and Van den brink G. V. (1986). Energy storage in phase change materials for solar applications. International Journal of Ambient Energy 7: 31. [151] De Maria G., D'Alessio L., Coffari E., Paolucci M. and Tiberio C. A. (1985). Thermo-chemical storage of solar energy with high temperature chemical reaction. Solar Energy, 35(5): 409-416. [152] Fujii I., Tsuchiya K., Higano M. and Yamada J. (1985). Studies on an energy system by use of the reversible chemical reaction. Solar Energy 34(4-5): 367- 377. [153] Abhat A. (1981). Short term thermal energy storage. Revue Physique Applique 15: 477-501. 189
[154] Brendel T., Solare Meerwasserentsalzungsanlagen mit mehrstufiger Verdunstung, Betriebsversuche, dynamische Simulation und Optimierung., Ph.D. Thesis, Fakultät für Maschinenbau der Ruhr-Universität Bochum, 2003. [155] Chafik E, “A new seawater desalination process using solar energy,” Desalination, 2002, pp. 153:25–37. [156] Orfi, J., Laplante, M., Marmouch, H., Galanis, N., Benhamou, B., Nasrallah S. B., Nguyen, C.T.. Experimental and theoretical study of a humidification dehumidification water desalination system using solar energy. Desalination 168 (2004):151. [157] Beasley D.E. (1983). Dynamic response of packed bed for thermal energy storage. Ph.D. Thesis, University of Michigan. [158] International Atomic Energy Agency. Desalination Economic Evaluation Programme, Version DEEP-3.1; Draft version of the user’s manual, Vienna, September 2006. [159] Nawayseh, N.K., Farid, M.M., AL-Hallaj, S. and Tamimi, A.R., 1999; Solar desalination based on humidification process-I evaluating the heat and mass transfer coefficients. Energy Conversion and Management, 1999a, 40:1423- 1439. 190
Page 1:
Technische Universität München In
Page 4 and 5:
It is my pleasure to thank Prof. Th
Page 6 and 7:
Contents List of figures ..........
Page 8 and 9:
5.3 Functional description ........
Page 10 and 11:
List of Figures Figure 1.1: Cost br
Page 12 and 13:
78cm; Top: Evaporator, Bottom: Cond
Page 14 and 15:
xii
Page 16 and 17:
m Mass flow rate; [kg.s -1 ] m eva
Page 18 and 19:
ed c coll cond cw d d e or eff evap
Page 20 and 21:
1 Introduction The first part of th
Page 22 and 23:
summarized in figure (1.2). Thermal
Page 24 and 25:
1.3.2 Selection criteria of desalin
Page 26 and 27:
of energy storage or hybridization
Page 28 and 29:
Desalination development focuses on
Page 30 and 31:
Introduction of the indirect type s
Page 32 and 33:
2 Literature Survey 2.1 Introductio
Page 34 and 35:
There is actually a commercial prod
Page 36 and 37:
Q m H c ( T T1) c ( T 2 T ) (2.2)
Page 38 and 39:
(solid-liquid) have a storage densi
Page 40 and 41:
(iii) a sharp melting temperature.
Page 42 and 43:
melt and freeze without segregation
Page 44 and 45:
However, the stored heat is less va
Page 46 and 47:
parameters on the heat transfer and
Page 48 and 49:
categories. The first category is b
Page 50 and 51:
to 550 kWh/m 3 of distilled water a
Page 52 and 53:
The enthalpy and humidity of the sa
Page 54 and 55:
Air mass flow rate [kg/h] GOR [-] 1
Page 56 and 57:
On the other hand, the efficiency o
Page 58 and 59:
2.8.4.2 Effect of air to water mass
Page 60 and 61:
distillate rate. The system was not
Page 62 and 63:
were; EnviPac Gr.1, 32 mm, and VFF
Page 64 and 65:
Figure 2.15: Height versus air temp
Page 66 and 67:
The performance of the condenser is
Page 68 and 69:
Klausner and Mei [136] described a
Page 70 and 71:
The impact of the collector cost ca
Page 72 and 73:
exchanger and energy storage in one
Page 74 and 75:
3 Scope of the Study This chapter p
Page 76 and 77:
packing where it gets in direct con
Page 78 and 79:
In fact there is a tradeoff between
Page 80 and 81:
The energy flow between all and eac
Page 82 and 83:
4 Theoretical Analysis and Modeling
Page 84 and 85:
The two-energy equation models whic
Page 86 and 87:
solid-liquid phase change inside th
Page 88 and 89:
assumed by conduction in both axial
Page 90 and 91:
the air pressure drop ∆P per unit
Page 92 and 93:
evaporation rate per unit volume of
Page 94 and 95:
where β t , β c , ρ ref , c ref
Page 96 and 97:
the viscous transport and introduce
Page 98 and 99:
liquid and solid phases, respective
Page 100 and 101:
4.2.3.3 Liquid and gas hold-ups Liq
Page 102 and 103:
Several models and approaches for m
Page 104 and 105:
where G=ρU d /ε g is the pore mas
Page 106 and 107:
k k eff s 1 3 2 (4.55) This cor
Page 108 and 109:
uncertainties associated with the f
Page 110 and 111:
1 2 (4.62) d1 capp c2 c1 c2 1
Page 112 and 113:
[58] evaluated the cooling tower ai
Page 114 and 115:
1 exp NTU 1 C r, cond cond (4
Page 116 and 117:
A HE QHE U T HE LM (4.81) Where Q
Page 118 and 119:
c M f b (4.86) M b S S f where r
Page 120 and 121:
that form the study logical foundat
Page 122 and 123:
5 Experimental Analysis This chapte
Page 124 and 125:
5.2 Measuring Techniques K-type the
Page 126 and 127:
The product condensed water was mea
Page 128 and 129:
operating limits. In light of the l
Page 130 and 131:
In the last two cases, the inlet ho
Page 132 and 133:
performance and its threshold value
Page 134 and 135:
It could be interpreted that this p
Page 136 and 137:
Evaporator Condenser Figure 5.8: Av
Page 138 and 139:
within the inaccuracy margins. The
Page 140 and 141:
The last two cases of boundary cond
Page 142 and 143:
natural air flow in the system. In
Page 144 and 145:
6 Model Implementation and Validati
Page 146 and 147:
x t u x u 0 0 , (6.5) and for a s
Page 148 and 149:
Next time step validation were the
Page 150 and 151:
The evaporator and condenser both w
Page 152 and 153:
Figure 6.2: Evolution of inlet and
Page 154 and 155:
Figure 6.4: Evolution of inlet and
Page 156 and 157:
temperature is at its maximum level
Page 158 and 159: Bottom Top Figure 6.7: Evolution of
Page 160 and 161: 7 Parameters Analysis of the Evapor
Page 162 and 163: Figure 7.1: Effect of packing size
Page 164 and 165: e 0.45 kPa under natural convection
Page 166 and 167: aspect ratio under constant bed vol
Page 168 and 169: Figure 7.7: Effect of inlet hot wat
Page 170 and 171: well as the time required to reach
Page 172 and 173: Figure 7.10: Effect of packing medi
Page 174 and 175: 40°C respectively. This gives flex
Page 176 and 177: the condensate rate, productivity f
Page 178 and 179: esult, rather than PCM media which
Page 180 and 181: Figure 7.18: Effect of PCM thermal
Page 182 and 183: 8 Optimization of HDH plant In this
Page 184 and 185: The MATLAB model describes how the
Page 186 and 187: less steep than that of the distill
Page 188 and 189: 8.3.4 Effect of hot water flow rate
Page 190 and 191: storage materials and thus it can h
Page 192 and 193: for latent heat storage would be ob
Page 194 and 195: When T m becomes sufficiently highe
Page 196 and 197: 9 Summary and conclusions 9.1 Summa
Page 198 and 199: productivities at any cooling water
Page 200 and 201: [13] Vafai K., Sozen M. An investig
Page 202 and 203: [48] Crone S., Bergins C., and Stra
Page 204 and 205: [79] Tiwari G.N. and Yadav Y.P. (78
Page 206 and 207: [109] Mehling H., Hiebler S. and Zi
Page 210 and 211: Appendices Appendix A A1. PCM Therm
Page 212 and 213: A3. Constants and Thermo-physical p
Page 214 and 215: From the above correlation, the con
Page 216 and 217: The Ergun analogy factor J h repres
Page 218 and 219: Equation (C.7) represents an overal
Page 220 and 221: Appendix D D1. Cooling tower theory
Page 222 and 223: A m w = the plan or cross sectiona
show all

Experimental and Numerical Analysis of a PCM-Supported ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?