2110XP Ammonia Analyzer User Guide (1574 Kb) - Thermo Scientific

Chapter II Instrument Preparation
Unpacking the
Instrument
The Thermo Scientific Orion 2110XP ammonia monitor has been
assembled, tested and packaged with great care. Refer to Figure II-1.
Report any obvious damage of shipping container to carrier and hold for
inspection. The carrier (not Thermo Fisher Scientific) is responsible for
any damage incurred during shipment.
1. Open outer box. Remove top two foam corner support pieces.
2. Open inner box. This box should contain (1) each of the following
items:
• Orion 2110XP ammonia monitor and ATC temperature probe.
• Ammonia electrode box.
• Reference electrode box.
• Ammonia standard solutions kit: (2) x 2 oz bottles of 191 ppm
ammonia standard and (2) x 2 oz bottles of 1920 ppm ammonia
standard
• Options kit: cable glands, conduit fitting, fuse kit, green screw
terminal
• User guide CD.
3. Remove the cardboard retaining shell by sliding over the entire
mounting board and the monitor.
4. Carefully remove entire mounting board with monitor from inner box.
Note: Do not lift or pull instrument by the fluidics or electronic
components.
5. Unbolt the monitor from mounting board by removing the 4 mounting
bolts with a 9/16 wrench. These bolts may be discarded.
Figure II-1
Unpacking the Instrument
6. Carefully place the monitor at a convenient location until proper
installation can be completed.
Thermo Scientific Orion 2110XP Ammonia Monitor User Guide
II-1