BaseStation 3200 User Manual â 11.7.5.15 ... - Baseline Systems

More documents

Recommendations

Info

BaseStation 3200 Advanced Irrigation Controller Manual On-Screen Help At the bottom of every screen, there are instructions that describe how to use the buttons to change the functions associated with that screen. The instructions on the screen change depending on the functions and control requirements. Auto Run Main Screen The main screen displays when the dial is in the Auto Run position. This screen shows status for all elements of the 3200 controller. Air Temp – Shows “None” if no air temperature sensor is connected to the system, otherwise shows the current air temperature. Remote – Indicates the status of remote communications to the 3200. Possible indicators include: • None – No remote communication devices were detected. • Idle – One or more remote communication devices were detected, but none are in use at this time. • BL Commander – A BL Commander remote control is currently active. • Active – BaseManager central control software is currently connected to and communicating with the controller. Two-wire – Indicates the approximate current being supplied to the two-wire path. The value will vary with the size of the installation and the number of active valves. When the system is not watering, the two-wire status is OFF. Flow – If there is no flow meter installed, the controller shows the estimated flow (in brackets) based on the flow values that have been set for each zone. With one or more flow meters, the controller indicates the total flow measured. This value is updated once each minute, and is shown without brackets. More detail is available in the flow reports. Prog – Shows the status of all programs. Refer to the status color key on the label inside the door of the controller. MV – Shows the status of each master valve. Zone Status – The lower section shows the current status of the zones in groups of 50 zones. Press the + or – button to move between the groups 50 zones. Page 34
BaseStation 3200 Advanced Irrigation Controller Manual Status Colors The following colors display on the Auto Run screen to indicate the status of programs, master valves, flow meters, and zones. Idle (watering done) Active (watering) Waiting to water Soaking Disabled Paused Off or Message (blinking) Unused On-Screen Reports Follow the on-screen instructions to access reports from the main screen. Note: Refer to Notes, Messages, Alerts, and Logs on page 75 for the complete description of the on-screen reports. 1. Turn the dial to the Auto Run position. 2. Press the NEXT or PREV button to cycle through the report pages. 3. Press the + or – button while on any report page to see more reports or messages for each screen. Note: Messages can include status or warning messages, or serious controller alarms. Messages are prioritized with the most serious messages automatically being shown first in the Messages report screen. Page 35
Page 1 and 2: BaseStation 3200 Advanced Irrigatio
Page 3 and 4: Table of Contents 1 - INTRODUCTION
Page 5 and 6: 6 - INITIAL PROGRAMMING ...........
Page 7 and 8: Troubleshooting the Two-Wire: High
Page 41: BaseStation 3200 Advanced Irrigatio
Page 93 and 94:
BaseStation 3200 Advanced Irrigatio
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
show all

BaseStation 3200 User Manual â 11.7.5.15 ... - Baseline Systems

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?

BaseStation 3200 User Manual â 11.7.5.15 ... - Baseline Systems