BaseStation 3200 User Manual – 11.7.5.15 ... - Baseline Systems

BaseStation 3200 Advanced Irrigation Controller Manual
10 – REPORTS, MESSAGES, ALERTS, & LOGS
The main screen shows information about the operating state of the BaseStation controller. The controller
provides the following categories of reports and each category can have multiple reports.
• Zone Status
• Program Status
• Moisture Sensor Data
• Flow Meters and Water Used
• Pause Conditions
• Operator Messages
Some reports, messages, and alerts are only available when specific conditions cause them to be generated. For
example, if the main screen indicates that a pause condition has occurred, you can access the Pause Condition
report by pressing NEXT four times from the main screen.
If you clear the pause condition, this report does not display until the next time a pause condition occurs. If no
pause condition exists on the controller, pressing NEXT four times from the main screen displays the Operator
Messages. If no messages exist, the main screen displays.
You can also press PREV to navigate through the reports.
Zone Status
When the controller’s dial is in the Auto Run position, the main screen displays the Zone Status report.
When “BUSY” displays on the top line, the dial and buttons are locked out and will not work for a time. The busy
time can be several seconds, depending on the number of devices on the two-wire and the number of calculations
being done.
Page 75