BaseStation 3200 User Manual – 11.7.5.15 ... - Baseline Systems

BaseStation 3200 Advanced Irrigation Controller Manual
Manually Running the Zones of a Program
1. Turn the dial to the Manual Water position.
2. In the first field on the screen, press the + button to change the setting
to Run Zones of Program.
3. Press the NEXT button to move to the next field, and then press the +
or – button to select the program that you want to run manually.
Note: If you decide that you do not want to start a manual run after
you have selected a program, press the CLR button to change the
setting to OFF.
4. Press the NEXT button to move to the Zone Run Time field, and then
press the + or – button to set the amount of time that you want each
zone in the program to run.
5. Press the NEXT button to move to the First Zone Delay field, and then press the + or – button to set the
amount of time that you want the system to delay before the first zone starts running.
Note: Use the First Zone Delay setting to give you time to walk to the zone location so you can observe the
zone running.
6. Press the NEXT button to move to the Between Zone Delay field, and then press the + or – button to set the
amount of time that you want the system to delay before another
zone starts running.
7. When you have finished making changes, turn the dial to the Auto Run
position. When the manual run starts, the main screen shows the
details.
8. If you want to stop the manual run while it is active, press the CLR
button.
Note: When the manual run is complete, the controller changes the
Manually Run Zone(s) setting to OFF.
Page 68