BaseStation 3200 User Manual â 11.7.5.15 ... - Baseline Systems
BaseStation 3200 User Manual â 11.7.5.15 ... - Baseline Systems
BaseStation 3200 User Manual â 11.7.5.15 ... - Baseline Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>BaseStation</strong> <strong>3200</strong> Advanced Irrigation Controller <strong>Manual</strong><br />
5. Press the NEXT button to move to the First Zone Delay field, and then press the + or – button to set the<br />
amount of time that you want the system to delay before the zone starts running.<br />
Note: Use the First Zone Delay setting to give you time to walk to the zone location so you can observe the<br />
zone running. You can set the delay time from 0 seconds to 10 minutes.<br />
6. Press the NEXT button to move to the Between Zone Delay field, and then press the + or – button to set the<br />
amount of time that you want the system to delay before another zone starts running.<br />
Note: If you are only running one zone, you can leave this field set to 0<br />
(zero).<br />
7. When you have finished making changes, turn the dial to the Auto Run<br />
position. When the manual run starts, the main screen shows the<br />
details.<br />
8. If you want to stop the manual run while it is active, press the CLR<br />
button.<br />
Note: When the manual run is complete, the controller changes the<br />
<strong>Manual</strong>ly Run Zone(s) setting to OFF.<br />
<strong>Manual</strong>ly Running All Zones<br />
1. Turn the dial to the <strong>Manual</strong> Water position.<br />
2. Make sure that the first field on the screen says <strong>Manual</strong>ly Run Zone(s).<br />
If another option displays in this field, press the + button to change the<br />
option to <strong>Manual</strong>ly Run Zone(s).<br />
3. Press the NEXT button to move to the next field, and then press the +<br />
or – button to select All. If the field is set to OFF, press the + button<br />
one time to change the field to the lowest numbered zone, and then<br />
press the – button one time to change the setting to All.<br />
Note: If you decide that you do not want to start a manual run after<br />
you have selected All, press the CLR button to change the setting to<br />
OFF.<br />
4. Press the NEXT button to move to the Zone Run Time field, and then press the + or – button to set the<br />
amount of time that you want each zone to run.<br />
5. Press the NEXT button to move to the First Zone Delay field, and then press the + or – button to set the<br />
amount of time that you want the system to delay before the first zone starts running.<br />
Note: Use the First Zone Delay setting to give you time to walk to the zone location so you can observe the<br />
zone running.<br />
6. Press the NEXT button to move to the Between Zone Delay field, and<br />
then press the + or – button to set the amount of time that you want<br />
the system to delay before another zone starts running.<br />
7. When you have finished making changes, turn the dial to the Auto Run<br />
position. When the manual run starts, the main screen shows the<br />
details.<br />
8. If you want to stop the manual run while it is active, press the CLR<br />
button.<br />
Note: When the manual run is complete, the controller changes the <strong>Manual</strong>ly Run Zone(s) setting to OFF.<br />
Page 67
Change language