TOPS Pro Tutorial - TOPS - Packaging Software

1. Click on the CASY Primary Package icon – – in the Toolbar.
System Response: The CASY Primary Package Screen appears, as
pictured below.
2. Use your mouse to click on the left edge of the work unit (on the left)
and mark off four distinct sections, as pictured below.
Notice that the display unit shows four clearly defined sections.
3. One by one, click on each marker on the left edge of the work unit and
drag it toward the center of the unit; leave the last marker (flush
bottom) where it is. Use the figure on the next page as a guide.
When you drag a marker from the left, the point on the opposite side
moves toward the center as well to give the figure symmetry. This
defines the overall shape of the sections that comprise the oil can.
TOPS Pro Tutorial 39