tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...

More documents

Recommendations

Info

Technical data 13 Technical data 13.1 TAINY HMOD-V3-IO, TAINY HMOD-L3-IO Interfaces Application interface Security functions Additional functions 2 x 10/100 Base-T (RJ45 plug) Ethernet IEEE802 10/100 Mbit/s Service interface USB-A (reserved for later applications) VPN Firewall VPN IPSec (TAINY HMOD-V3-IO only) Such as 10 VPN tunnel Stateful inspection firewall Anti-spoofing Port forwarding DNS cache, DHCP server, NTP, remote logging, connection monitoring, alarm-SMS Management Web-based administration user interface, SSH console Wireless connection Ambient conditions Frequency bands UMTS/HSPA+: 800/850, 900, 1900, 2100 MHz GSM/GPRS/EDGE: 850, 900, 1800, 1900 MHz HSPA+ HSDPA/HSUPA Datenraten: DL: 7.2 / 14.4 Mbps, UL: 2.0 / 5.76 Mbps Concurrent data rate: DL: 7.2 Mbps, UL: 5.76 Mbps UMTS DL: max. 384 kbps, UL: max. 384 kbps EDGE (EGPRS) EDGE class 12: GPRS GPRS class 12: DL: max. 237 kbps, UL: max. 237 kbps DL: max. 85.6 kbps, UL: max. 85.6 kbps CSD / MTC CSD data transmission 14.4 kbps, V.110 SMS (TX) Point to point, MO (outgoing) Antenna connections Temperature range Nominal impedance: 50 ohms, jack: SMA Operation: -40 °C bis +70 °C *) Storage: -40 °C bis +70 °C *) Automatische Abschaltung des Funkmoduls bei kritischer Temperatur. Air humidity 0-95 %, non-condensing Housing Design Top-hat rail housing Material Plastic Protection class IP20 Dimensions 114 mm x 45 mm x 99 mm Weight approx. 280g Page 108 of 111 TAINY xMOD
Conformity CE Conforms to Directive 99/05/EC Power supply R&TTE Conform to directive 99/05/EC Applied statndards: HSPA+/UMTS/ GSM/EGPRS- Modul EN301 511 v.9.0.2, EN301908-1/-2 v.4.2.1 Konform zu GCF, PTCRB EMC/ESD Applied standards: EN 301 489-1 v.1.8.1, EN 301 489-7 v.1.3.1, EN 61000-6-2:2005 Electrical safety Angewandte Norm: EN 60950-1:11-2006/A1:2010 Technical data Environment The device complies with the European Directives RoHS and WEEE. Input voltage nominal 12-60 VDC, min. -10%, max +20% Power input 4.4 W typical at 12 V 4.0 W typical at 24 V 5.5 W typical at 60 V Supply current 450mA at 12V and 100mA at 60V Iburst = 1.26A TAINY xMOD Page 109 of 111
Page 1 and 2:
User Manual TAINY HMOD-V3-IO, TAINY
Page 3 and 4:
Products ! Safety instructions The
Page 5 and 6:
Firmware with open source GPL/LGPL
Page 7 and 8:
Contents Contents 1 Introduction ..
Page 9 and 10:
1 Introduction Introduction Product
Page 11 and 12:
Introduction Local applications cou
Page 13 and 14:
Terms Here are definitions of terms
Page 15 and 16:
2 Setup 2.1 Step by step Set up the
Page 17 and 18:
2.3 Overview 2.4 Service button Set
Page 19 and 20:
TAINY EMOD Lamp Status Meaning S (S
Page 21 and 22:
2.6 Connections LAN0, LAN1 (10/100
Page 23 and 24:
24V / 0V power supply The TAINY xMO
Page 25 and 26:
3 Configuration 3.1 Overview Remote
Page 27 and 28:
Preferred DNS server Configuration
Page 29 and 30:
The start page is not displayed If
Page 31 and 32:
Signal (CSQ Level) Indicates the st
Page 33 and 34:
Carrying out configuration ONLY TAI
Page 35 and 36:
Function Access to the TAINY xMOD i
Page 37 and 38:
4 Local interface 4.1 IP addresses
Page 39 and 40:
4.3 DNS to local network Local Netw
Page 41 and 42:
Poll interval Serve system time to
Page 43 and 44:
Provider selection mode - Manual Pr
Page 45 and 46:
Provider selection mode - Automatic
Page 47 and 48:
Activity on faulty connection Renew
Page 49 and 50:
Remote host 0.0.0.0 Group group Use
Page 51 and 52:
5.7 Volume supervision External net
Page 53 and 54:
Security functions Protocol Select
Page 55 and 56:
6.2 Port Forwarding Security > Port
Page 57 and 58: 6.4 Firewall Log Security > Firewal
Page 59 and 60: Requirements for the remote network
Page 61 and 62: VPN connections CA certificate The
Page 63 and 64: VPN connections ISAKMP-SA mode Agre
Page 65 and 66: VPN Standard Mode Edit Settings Con
Page 67 and 68: VPN connections Remote net address
Page 69 and 70: VPN Standard Mode Edit IKE VPN conn
Page 71 and 72: 7.4 Loading VPN certificates IPsec
Page 73 and 74: 7.6 Supervision of VPN connections
Page 75 and 76: Number of connect attempts until re
Page 77 and 78: Action Define how access to the spe
Page 79 and 80: Factory setting The factory setting
Page 81 and 82: 9 Status, log and diagnosis 9.1 Log
Page 83 and 84: Status, log and diagnosis Function
Page 85 and 86: Status, log and diagnosis Function
Page 87 and 88: Additional functions Text Here ente
Page 89 and 90: Port number 26864 Firewall Rules No
Page 91 and 92: The following parameters of the TAI
Page 93 and 94: Target host NONE Target port 162 Ta
Page 95 and 96: Asymmetric encryption CIDR Small le
Page 97 and 98: Small lexicon of routers CSQ / RSSI
Page 99 and 100: Small lexicon of routers EGPRS EGPR
Page 101 and 102: IPsec MIB See SNMP Small lexicon of
Page 103 and 104: Protocol, Transfer protocol Small l
Page 105 and 106: X.509 certificate A type of "seal"
Page 107: Network B Computer B1 B2 B3 B4 Addi
Page 111: Protection class IP20 Dimensions 11
show all

tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?