tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Number of connect<br />
attempts until reboot of<br />
the device, after an<br />
unsuccessful restart of<br />
the VPN client<br />
VPN connect<strong>io</strong>ns<br />
If the establishment of a VPN connect<strong>io</strong>n fails, the connect<strong>io</strong>n setup will be<br />
retried by the TAINY xMOD-V3-IO. Enter the number of unsuccessful retries,<br />
being performed before the TAINY xMOD-V3-IO reboots and tries again the<br />
connect<strong>io</strong>n setup.<br />
DynDNS Tracking If the VPN gateway of the remote stat<strong>io</strong>ns uses a DynDNS service to get an<br />
IP address and no Dead Peer Detect<strong>io</strong>n is used, the TAINY xMOD-V3-IO<br />
should per<strong>io</strong>dically check, if the remote VPN gateway is still reachable. The<br />
DynDNS tracking funct<strong>io</strong>n provides this funct<strong>io</strong>n. Yes activates this funct<strong>io</strong>n,<br />
No deactivate this funct<strong>io</strong>n.<br />
DynDNS Tracking<br />
Interval (Minutes)<br />
Configure here the interval it shall be checked, if the remote stat<strong>io</strong>n is still<br />
reachable.<br />
Factory setting The factory settings used by the TAINY xMOD-V3-IO are as follows:<br />
NAT-T keepalive interval (seconds) 60<br />
Phase 1 timeout (seconds) 15<br />
Phase 2 timeout (seconds) 10<br />
Number of connects attempts until restart<br />
of the VPN client<br />
Number of connect attempts until reboot<br />
of the device, after an unsuccessful<br />
restart of the VPN client<br />
7.8 Status of the VPN connect<strong>io</strong>ns<br />
IPsec VPN ><br />
Connect<strong>io</strong>ns<br />
ONLY TAINY HMOD-V3-IO<br />
ONLY TAINY EMOD-V3-IO<br />
DynDNS Tracking No (Nein)<br />
DynDNS Tracking Interval (Minutes) 5<br />
Restart of the VPN clients on DPD Nein<br />
Funct<strong>io</strong>n Indicates the status of the enabled VPN connect<strong>io</strong>ns and the opt<strong>io</strong>n for<br />
loading a protocol file to the Admin PC.<br />
Activated VPN<br />
connect<strong>io</strong>ns<br />
The respective security associat<strong>io</strong>n (SA) has been successfully<br />
established.<br />
The security associat<strong>io</strong>n has not been established.<br />
VPN reconnect counter<br />
(24h)<br />
Shows the number of attempts to establish the activated VPN connect<strong>io</strong>ns<br />
since 0:00 (system time)<br />
Download VPN protocol This funct<strong>io</strong>n can be used to download the VPN protocol file to the Admin<br />
PC.<br />
TAINY xMOD Page 75 of 111<br />
5<br />
2