tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Addit<strong>io</strong>nal funct<strong>io</strong>ns<br />
10 Addit<strong>io</strong>nal funct<strong>io</strong>ns<br />
10.1 SMS Service Center<br />
SMS Service Center<br />
SMS service center call<br />
number<br />
10.2 Alarm SMS<br />
SMS > Alarm SMS<br />
The TAINY xMOD uses the Short Message Service (SMS) of GSM. It is<br />
possible to define a certain SMS Center.<br />
So that the SMS funct<strong>io</strong>n will funct<strong>io</strong>n reliably, enter the call number of the<br />
service center here. Without an entry in this locat<strong>io</strong>n the default SMS service<br />
center of your network operator will be used.<br />
Attent<strong>io</strong>n:<br />
If no call number is entered for the SMS center or the entry is not made in<br />
the internat<strong>io</strong>nal format (e.g. +49...), then the SMS cannot be sent.<br />
Funct<strong>io</strong>n The TAINY xMOD can transmit short alarm messages via the SMS<br />
(= Short Message Service) of the GSM network. Two events can trigger<br />
transmiss<strong>io</strong>n of an alarm message via SMS:<br />
Alarm SMS Event 1:<br />
In Port<br />
Alarm SMS Event 2: No<br />
GPRS Connect<strong>io</strong>n<br />
� Event 1: In port is activated<br />
� Event 2: No UMTS/GPRS connect<strong>io</strong>n<br />
A separate call number for sending the alarm message to can be specified<br />
for each of these two events. The text of the alarm message can also be<br />
freely defined. The following characters are available: A-Z a-z<br />
0123456789,!?<br />
Event 1: the In port switches from inactive to active, i.e. sufficient switching<br />
voltage is applied at the In port. This funct<strong>io</strong>n can be used, for example to<br />
transmit alarm messages of the local applicat<strong>io</strong>ns outside of the IP data<br />
connect<strong>io</strong>ns.<br />
Event 2: the UMTS/GPRS connect<strong>io</strong>n is not established despite multiple<br />
attempts. The TAINY xMOD then transmits an alarm message.<br />
Settings Enable With Yes the alarm message is sent when the event occurs,<br />
with No it is not.<br />
Call number Here enter the call number of the end device to which the<br />
alarm message is to be sent via SMS. The end device must<br />
support SMS recept<strong>io</strong>n via GSM or fixed network.<br />
Page 86 of 111 TAINY xMOD