tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
24V / 0V power supply The TAINY xMOD operates with direct current of from 12-60 V DC,<br />
nominally 24 V DC. This power supply is connected at the screw terminals<br />
on the left-hand side of the device.<br />
In port<br />
I1+/ I1-<br />
Switching output<br />
O1a/ O1b<br />
The current consumpt<strong>io</strong>n is about 450mA at 12V and 100mA at 60V.<br />
Warning:<br />
The power supply unit of the TAINY HMOD-V3-IO is not isolated.<br />
Please observe the safety instruct<strong>io</strong>ns at the beginning of this manual.<br />
Note:<br />
Make sure that the supply source is sufficiently dimens<strong>io</strong>ned. Instable<br />
operat<strong>io</strong>n may occur if the supply is too weak.<br />
Setup<br />
The TAINY xMOD has an In port. The In port has connect<strong>io</strong>ns at the screw<br />
terminals on the right-hand side of the device. The terminals are designated<br />
I1+/I1-.<br />
I1+<br />
I1-<br />
UIn = 5 …30V; ON: UIn > 5 V; OFF: UIn < 1,2 V<br />
For more on the funct<strong>io</strong>n of the In port, see also Chapter 10.<br />
Warning:<br />
The In port is galvanically insulated against all other terminals of the TAINY<br />
xMOD. If the external installat<strong>io</strong>n being connected to the TAINY xMOD<br />
connects a signal of the In port galvanically to a power supply signal of the<br />
TAINY xMOD, the voltage between each signal of the In port and each<br />
signal of the power supply may not exceed 60V.<br />
The TAINY xMOD-V3-IO has a switching output. The switching output has<br />
its connect<strong>io</strong>ns at the screw terminals on the right-hand side of the device.<br />
The terminals are designated O1a/O1b.<br />
O1a<br />
O1b<br />
UMax = 30V; IMax = 20mA<br />
The switching output is active (switch closed) if at least one VPN connect<strong>io</strong>n<br />
is established.<br />
The switching output is not active (switch opened) if no VPN connect<strong>io</strong>n is<br />
established.<br />
Warning:<br />
The switching output is galvanically insulated against all other terminals of<br />
the TAINY xMOD. If the external installat<strong>io</strong>n being connected to the TAINY<br />
xMOD connects a signal of the switching output galvanically to a power<br />
supply signal of the TAINY xMOD, the voltage between each signal of the<br />
switching output and each signal of the power supply may not exceed 60V.<br />
TAINY xMOD Page 23 of 111
Change language