tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...

Factory setting The factory settings for the TAINY xMOD are as follows:
Enable SSH remote access No (switched off)
SSH remote access port 22
Default for new rules:
From IP (External) 0.0.0.0/0
Action Accept
8.3 Remote access via dial-in connection
Access >
CSD Dial-In
Function
ONLY for TAINY HMOD
Log No (switched off)
Remote access
The CSD dial-in access makes it possible to access the Web user interface
of the TAINY xMOD via a dial-in data connection (CSD = Circuit Switched
Data). To do this, call the TAINY xMOD at the data call number using an
analogue modem, or at the voice or data call number of its SIM card using a
GSM modem. The TAINY xMOD accepts the call if:
� the call number of the telephone connection that you call from is saved
in the list of permitted numbers in TAINY xMOD, and
� the call number is transmitted by the telephone network (CLIP
function)
Dialling must be performed by a PPP client, for example via a Windows dialup
connection. In Windows, use the New Connection Wizard, and under
Connect to the network at my workplace set up a Dial-up connection.
Web interface and ssh console have the IP address 10.99.99.1. in case of
CSD Dial-In.
Note
This function is available only, if a GSM network is used. In UMTS networks,
this function cannot be used.
Enable CSD dial-in Yes Access to the Web user interface of the TAINY xMOD from a
dial-in data connection is allowed.
PPP username /
password
No Access via dial-in data connection is not allowed.
Select a username and a password that must be used by a PPP client (e.g.
a Windows dial-up connection) to log on to the TAINY xMOD. The same
username and the same password must be entered in the PPP client.
TAINY xMOD Page 79 of 111