tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...

More documents

Recommendations

Info

External interface 5.2 UMTS/GPRS connection monitoring External Network > Advanced Settings > Connection Check Function With the function Connection Check the TAINY xMOD checks its connection to UMTS/GPRS and to the connected external networks, such as the internet or an intranet. To do this, the TAINY xMOD sends ping packets (ICMPs) to up to four remote stations (target hosts) at regular intervals. This takes place independently of the user data connections. If after such a ping the TAINY xMOD receives a response from at least one of the remote stations addressed, then the TAINY xMOD is still connected with the UMTS/GPRS and ready for operation. Some network operators interrupt connections when they are inactive. This is likewise prevented by the Connection Check function. Local application Warning TAINY Ping for connection monitoring HSPA+, UMTS (E-)GPRS Page 46 of 111 TAINY xMOD APN Destination host on the Internet User data connection INTERNET Router/ Firewall Remote network Destination host on the Intranet Note: HSPA+ and UMTS are supported by the TAINY HMOD only. Sending ping packets (ICMPs) increases the amount of data sent and received via the UMTS/GPRS. The additional data traffic can add up to 2.5 Mbyte per month (ping to IP address) or 6 Mbyte per month (Ping to hostname), depending on the settings selected. This can lead to increased costs. Enable connection check Yes activates the function. Ping Targets - Hostname Select up to four remote stations that the TAINY xMOD can ping. The remote stations must be available continuously and must answer pings. Connection check interval (minutes) Allowable number of failures Note Make sure that the selected remote stations will not feel "harassed". Specifies the interval at which the connection check ping packets are sent by the TAINY xMOD. This is specified in minutes. Specifies how many times it is allowed for all ping packets of an interval not to receive an answer, i.e. for none of four pinged remote stations to answer, before the specified action is carried out.
Activity on faulty connection Renew Connection Reboot TAINY xMOD External interface The TAINY xMOD re-establishes the connection to the UMTS/GPRS if the ping packets sent were not answered. The TAINY xMOD carries out a reboot if the ping packets sent were not answered. Factory setting The factory settings for the TAINY xMOD are as follows: 5.3 Hostname via DynDNS External Network > Advanced Settings > DynDNS Enable connection check No (switched off) Hostname - Connection check interval 5 (minutes) Allowable number of failures 3 (failed attempts) Activity on faulty connection Renew Connection Function Dynamic domain name servers (DynDNS) make it possible for applications to be accessible on the Internet under a hostname (e.g. myHost.org), even if these applications do not have a fixed IP address and the hostname is not registered. If you log the TAINY xMOD on to a DynDNS service, you also can reach the TAINY xMOD from external network under a hostname, e.g. myTainy.dyndns.org. Log this TAINY on to a DynDNS server Log on interval (seconds) DynDNS username / password For more information on DynDNS see Chapter 11. Local application TAINY INFO: IP address + hostname HSPA+, UMTS (E-)GPRS TAINY xMOD Page 47 of 111 APN User data connection DynDNS INTERNET Select Yes if you want to use a DynDNS service. The TAINY xMOD is compatible with dyndns.org. Question: IP for the hostname Response: IP Router/ Firewall External network Note: HSPA+ and UMTS are supported by the TAINY HMOD only. Enter here the username and the password that authorise you to use the DynDNS service. Your DynDNS provider will give you this information.
Page 1 and 2: User Manual TAINY HMOD-V3-IO, TAINY
Page 3 and 4: Products ! Safety instructions The
Page 5 and 6: Firmware with open source GPL/LGPL
Page 7 and 8: Contents Contents 1 Introduction ..
Page 9 and 10: 1 Introduction Introduction Product
Page 11 and 12: Introduction Local applications cou
Page 13 and 14: Terms Here are definitions of terms
Page 15 and 16: 2 Setup 2.1 Step by step Set up the
Page 17 and 18: 2.3 Overview 2.4 Service button Set
Page 19 and 20: TAINY EMOD Lamp Status Meaning S (S
Page 21 and 22: 2.6 Connections LAN0, LAN1 (10/100
Page 23 and 24: 24V / 0V power supply The TAINY xMO
Page 25 and 26: 3 Configuration 3.1 Overview Remote
Page 27 and 28: Preferred DNS server Configuration
Page 29 and 30: The start page is not displayed If
Page 31 and 32: Signal (CSQ Level) Indicates the st
Page 33 and 34: Carrying out configuration ONLY TAI
Page 35 and 36: Function Access to the TAINY xMOD i
Page 37 and 38: 4 Local interface 4.1 IP addresses
Page 39 and 40: 4.3 DNS to local network Local Netw
Page 41 and 42: Poll interval Serve system time to
Page 43 and 44: Provider selection mode - Manual Pr
Page 45: Provider selection mode - Automatic
Page 49 and 50: Remote host 0.0.0.0 Group group Use
Page 51 and 52: 5.7 Volume supervision External net
Page 53 and 54: Security functions Protocol Select
Page 55 and 56: 6.2 Port Forwarding Security > Port
Page 57 and 58: 6.4 Firewall Log Security > Firewal
Page 59 and 60: Requirements for the remote network
Page 61 and 62: VPN connections CA certificate The
Page 63 and 64: VPN connections ISAKMP-SA mode Agre
Page 65 and 66: VPN Standard Mode Edit Settings Con
Page 67 and 68: VPN connections Remote net address
Page 69 and 70: VPN Standard Mode Edit IKE VPN conn
Page 71 and 72: 7.4 Loading VPN certificates IPsec
Page 73 and 74: 7.6 Supervision of VPN connections
Page 75 and 76: Number of connect attempts until re
Page 77 and 78: Action Define how access to the spe
Page 79 and 80: Factory setting The factory setting
Page 81 and 82: 9 Status, log and diagnosis 9.1 Log
Page 83 and 84: Status, log and diagnosis Function
Page 85 and 86: Status, log and diagnosis Function
Page 87 and 88: Additional functions Text Here ente
Page 89 and 90: Port number 26864 Firewall Rules No
Page 91 and 92: The following parameters of the TAI
Page 93 and 94: Target host NONE Target port 162 Ta
Page 95 and 96: Asymmetric encryption CIDR Small le
Page 97 and 98:
Small lexicon of routers CSQ / RSSI
Page 99 and 100:
Small lexicon of routers EGPRS EGPR
Page 101 and 102:
IPsec MIB See SNMP Small lexicon of
Page 103 and 104:
Protocol, Transfer protocol Small l
Page 105 and 106:
X.509 certificate A type of "seal"
Page 107 and 108:
Network B Computer B1 B2 B3 B4 Addi
Page 109 and 110:
Conformity CE Conforms to Directive
Page 111:
Protection class IP20 Dimensions 11
show all

tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...

Create successful ePaper yourself

Delete template?

Save as template?