tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
SNMP<br />
11.2 Alarm messages via SNMP traps<br />
SNMP – SNMP traps<br />
The TAINY xMOD sends messages in the form of SNMP traps for var<strong>io</strong>us<br />
events.<br />
Enable SNMP traps Select Yes if you want to activate the sending of SNMP traps.<br />
Select No if you want to switch off the sending of SNMP traps.<br />
Target host Enter the IP address of the SNMP trap recipient.<br />
Target port Enter the IP port of the SNMP trap recipient.<br />
Target name Enter the name of the SNMP trap recipient.<br />
Target community Enter the name of the SNMP community here.<br />
Send keepalive<br />
messages<br />
Device keepalive interval<br />
(minutes)<br />
Event: Warning level for<br />
monthly traffic volume<br />
reached<br />
Event: Maximum<br />
monthly traffic volume<br />
reached<br />
Event: Connect<strong>io</strong>n reestablished<br />
Event: Gate inout<br />
toggled<br />
Event: Configurat<strong>io</strong>n<br />
profile activated<br />
Select Yes if you want the TAINY xMOD keepalive packages to be sent as<br />
an SNMP trap.<br />
Select No if you do not want the TAINY xMOD keepalive packages to not be<br />
sent as an SNMP trap.<br />
Choose the interval which you want the keepalive SNMP traps to be sent at.<br />
Select Yes if you want the TAINY xMOD to send an SNMP trap upon<br />
reaching the warning threshold (80%) for the monthly data volume (see<br />
chapter 5.7).<br />
Select No if you do not want an SNMP trap to be sent for this event.<br />
Select Yes if you want the TAINY xMOD to send an SNMP trap upon<br />
reaching the maximum monthly data volume (see chapter 5.7).<br />
Select No if you do not want to set an SNMP trap for this event.<br />
Select Yes if you want the TAINY xMOD to send an SNMP trap when<br />
successfully re-establishing the connect<strong>io</strong>n to the APN.<br />
Select No if you do not want to set an SNMP trapfor this event.<br />
Select Yes if you want the TAINY xMOD to send an SNMP trap with a<br />
change at the switching input.<br />
Select No if you do not want an SNMP trap to be sent for this event.<br />
Select Yes if you want the TAINY xMOD to send an SNMP trap with the<br />
activat<strong>io</strong>n of a configurat<strong>io</strong>n profile.<br />
Select No if you do not want an SNMP trap to be sent for this event.<br />
Factory settings The TAINY xMOD has the following default settings:<br />
Activate SNMP traps No<br />
Page 92 of 111 TAINY xMOD