tainy hmod-v3-io, tainy hmod-l3-io - Dr. Neuhaus ...

Status, log and diagnosis
Function The TAINY xMOD can transfer the system log once per day via FTP (= File
Transfer Protocol) to an FTP server.
Enable remote logging
(FTP upload)
The current system log and the system log files in the archive are
transferred. After successful transfer the transferred logs are deleted in the
TAINY xMOD.
If the transfer fails, the TAINY xMOD -IO tries once again to transfer the data
after 24 hours.
Note
After an unsuccessful FTP upload, the log files are stored under
Maintenance > Remote Logging.
Yes activates the function.
Time Specifies the Time at which the logs are to be transferred.
FTP Server Specifies the address of the FTP server to which the log files are to be
transferred. The address can be specified as a hostname (e.g. ftp.server.de)
or as an IP address.
Username Specifies the username for logging in to the FTP server.
Password Specifies the password for logging in to the FTP server.
Factory setting The factory settings for the TAINY xMOD are as follows:
9.3 Snapshot
Maintenance >
Snapshot
Enable remote logging (FTP upload) No (switched off)
Time 00:00
FTP Server NONE
Username guest
Password guest
Function This function is used for support purposes.
The service snapshot downloads important log files and current device
settings that could be important for fault diagnosis and saves them in a file.
If you contact our customer service in the event of a problem with the TAINY
xMOD, in many cases they will ask you for the snapshot file.
Note
This file contains the access parameters UMTS/GPRS and the addresses of
the remote station. It does not contain the username and password for
access to the TAINY xMOD.
TAINY xMOD Page 83 of 111