MAINTENANCE MANUAL - Meritor

Specifcations
Mounting Bracket to Differential Repairs
MAINTENANCE MANUAL
Special Tools
1 - PLATES 8” (203,2 mm) Long X 3/4”(19,05 mm) THICk X 1-1/4” 931,75 mm) Wide With A Tongue To Fit Slot In Bar
Weld Plates To Bar
2 - -Handle 7”(177,8 mm) Long With Slot In One End To Fit Clamp Screw
3 - Bar 2”(50,8 mm) Diameter X 9” (228,6 mL) ong With One End Slotted To Fit Plate
4 - Weld All Around After Pressing Plug In Pipe
5 - Weld
6 - Shape And Size Of Holes To Fit Differential
7 - 23-1/2” (596,9 mm) Center To Center Of Pipe
8 - Chamfer End Of Pipe For Welding
9 - 4”(101.6) Diameter Pipe
10 - Plug 4” Diameter X 7” (177,8 mm) Long With One End Turned 3” (76,2 mm) Long To Fit Pipe. Drill 2” (50,8 mm)
Hole And Mill 3/16” Wide Slot 2” (50,8mm) From Top
11 - Screw 3” (88,9 mm) Long X 5/8” (15,96 mm) Diameter With Flats On End To Fit Handle And 2-1/2” (63,5 mm)
Length Of Thread On Other End
12 - Drill 3/8” (9,5 mm) Hole Through Handle And Screw
To obtain a repair stand, see to the Service Notes page on the front of this manual.
107