MAINTENANCE MANUAL - Meritor
MAINTENANCE MANUAL - Meritor
MAINTENANCE MANUAL - Meritor
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Tight Fit Forks and POSE Seal .<br />
1. Apply axle lubricant to the hub of the fork or<br />
flange. Figure 5.98.<br />
Inspect the fork<br />
and hub<br />
2. Verify that the lips of the POSE seal and<br />
the outer retainer of the triple-lip seal or main<br />
seal are clean and free from dirt and particles<br />
that may cause lubricant leakage between<br />
the seals.<br />
3. Install the POSE seal onto the hub of the fork<br />
or flange by hand. The lips of the seal must<br />
face toward the end of the hub, opposite shoulder.<br />
Slide the POSE seal onto the hub until<br />
the lips are 0.25-0.50-inch (6.4-12.7 mm) from<br />
the end of the hub. Do not install the POSE<br />
seal against the shoulder. Figure 5.99.<br />
<strong>MAINTENANCE</strong> <strong>MANUAL</strong><br />
LUBRICATE TRIPLE-LIP<br />
OR MAIN SEAL<br />
INPUT SHAFT OR<br />
PINON<br />
POSE SEAL<br />
0,25- 0,50” (6,4-12,7 mm)<br />
ONTO HUB<br />
Figure 5.98<br />
0,25 - 0,50<br />
(6,4 - 12,7 mm)<br />
FORK HUB<br />
FACE SEAL ASSEMBLY<br />
POSE SEAL ELEMENT<br />
Figure 5.99<br />
Assembly and Installation<br />
4.Before install the fork or flange in the shaft,<br />
apply axle lubricant to the hub.<br />
NOTE: The POSE seal will position itself<br />
correctly as the fork or flange is pressed on<br />
the shaft.<br />
5.nstall the fork or flange using the correct procedure.<br />
The fork must be completely seated before<br />
you tighten the pinion nut to the input shaft.<br />
77