MAINTENANCE MANUAL - Meritor
MAINTENANCE MANUAL - Meritor
MAINTENANCE MANUAL - Meritor
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Installation Case Halves and Ring Gear<br />
In the Differential<br />
1. If the bearing cones on the main differential<br />
case were removed, install a new cone and cap<br />
in a fully-matched set from the same manufacturer.<br />
The bearing cones are not interchangeable.<br />
Use a press and sleeve to install the<br />
cones in the case. Press only on the inner race<br />
of the bearing. Figure 5.30.<br />
BEARING CONE<br />
2. Clean and dry the bearing caps and bores of<br />
the differential legs and bearing caps.<br />
3. Apply axle lubricant to the bearing caps<br />
and cones.<br />
4. Apply adhesive 2297-T-418, evenly in the bearing<br />
bores and bearing caps of the legs the differential<br />
case. Cover the surfaces completely.<br />
The adhesive must not contact the adjusting<br />
ring threads. Figure 5.31. See the Section 4.<br />
5. Install the bearing caps over the bearing cones<br />
in the case halves. Figure 5.32.<br />
6. Safely lift the differential and ring gear assembly<br />
and install it inferential case. The bearing<br />
caps must be flat against the bores between<br />
the differential legs. Figure 5.32.<br />
<strong>MAINTENANCE</strong> <strong>MANUAL</strong><br />
PRESS<br />
SLEEVE<br />
Figure 5.30<br />
BEARING CUP<br />
Assembly and Installation<br />
Figure 5.31<br />
Figure 5.32<br />
7.Install the bearing adjusting rings between the<br />
differential legs. Hand-tighten the adjusting<br />
rings against the bearing caps. Figure 5.33.<br />
LEG<br />
ADHESIVE<br />
BEARING CAP<br />
DIFFERENTIAL<br />
CASE<br />
BEARING CUP<br />
CASES HALVES<br />
ADJUSTING<br />
RING<br />
Figure 5.33<br />
53