8b7PW0

Universal Garage Door Opener (If Equipped)To program another rolling code device,repeat Steps 1 through 6, substituting adifferent function button in Step 5.Fixed Code ProgrammingNote: It may be helpful to have anotherperson assist you in programming thetransmitter.To program units with fixed code DIPswitches, you will need the garage doorhand-held transmitter, paper and a pen orpencil.1. Switch the ignition on.2. Open the battery cover and note all theswitch settings from left to right.Note: You must complete the followingstep within 2.5 minutes.4. Enter the corresponding DIP switchsettings from left to right into the systemby pressing and releasing the buttonscorresponding to the settings you noted.5. Simultaneously press and release allthree function buttons. The LED lamps willilluminate.E164778• When the switch is in the up, on, or +position, mark down “left button”.• When the switch is in the middle,neutral, or 0 position, mark down“middle button”.• When the switch is in the down, off, or– position, mark down “right button”.3. Press all three function buttonssimultaneously for a few seconds and thenrelease. The LED lamps will flash slowly.E164776E1647766. Press and hold the function button youwould like to use to control the garagedoor.Note: You may need to hold the buttonfrom 5–55 seconds before observingmovement of the garage door.7. When the garage door moves, releasethe button within one second. After yourelease the button, the LED lamp will flashslowly.8. The LED lamp will begin to flash rapidlyuntil programming is complete. If yourgarage door does not operate, repeat theprevious steps. Otherwise, call the toll-freehelp line at 1-866-572-2728.The LED lamp above the selected buttonwill illuminate to confirm that the systemis responding to the button command.Erasing the Function Button CodesNote: You cannot erase individual buttons.1. Press and hold the outer two functionbuttons simultaneously for approximately20 seconds until the LED lamps above thebuttons flash rapidly126F150 (TF6) , enUSA