8b7PW0

Driving HintsTo install the floor mats, position the floormat eyelet over the retention post andpress down to lock in position.Remove in reverse order.SNOWPLOWINGFor F-150 snowplowing applications, Fordrecommends the F150 4X4 Regular Cab,SuperCrew or SuperCab, equipped withthe 6.2L engine for residentialsnowplowing only.Do not use F-150 vehicles equipped withthe 3.5L, 3.7L or 5.0L engines forsnowplowing.Installing the SnowplowWeight limits and guidelines for selectingand installing the snowplow are in the FordTruck Body Builders Layout Book,snowplow section, found atwww.fleet.ford.com/truckbbas. A typicalinstallation affects the following:• Certification to government safety lawssuch as occupant protection and airbagdeployment, braking, and lighting. Lookfor an Alterer’s Label on the vehiclefrom the snowplow installer certifyingthat the installation meets allapplicable Federal Motor VehicleSafety Standards (FMVSS).• The Total Accessory Reserve Capacity(TARC) is on the lower right side of thevehicle’s Safety ComplianceCertification Label. This applies toFord-completed vehicles of10,000.17 lb (4,536 kg) GVWR or less.This is the weight ofpermanently-attached auxiliaryequipment, such as snowplowframe-mounting hardware, that canbe added to the vehicle and satisfyFord compliance certification toFMVSS. Exceeding this weight mayrequire the auxiliary equipment installeradditional safety certificationresponsibility. The Front AccessoryReserve Capacity (FARC) is for thecustomer convenience.• Rear ballast weight behind the rearaxle may be required to preventexceeding the FGAWR, and providefront-to-rear weight balance for properbraking and steering.• Front wheel toe may requirere-adjustment to prevent prematureuneven tire wear. Specifications are inthe Ford Workshop Manual.• Headlight aim may require adjustment.212F150 (TF6) , enUSA