8b7PW0

Locks3. Enter your personal 5-digit code. Youmust enter each number within fiveseconds of each other.4. Press 1·2 on the keypad to savepersonal code 1.The doors will lock then unlock to confirmthat programming was successful.To program additional personal entrycodes, repeat Steps 1-3, then for Step 4:• Press 3·4 to save personal code 2.• Press 5·6, 7·8 or 9·0 to save personalcode 3.You may also program a personal entrycode through the MyFord Touch system.Tips:• Do not set a code that uses five of thesame number.• Do not use five numbers in sequentialorder.• The factory-set code will work even ifyou have set your own personal code.Recalling Memory Positions (IfEquipped)The programmed entry codes will recalldriver memory positions as follows:• Entry code 1 will recall driver 1 memorypositions.• Entry code 2 will recall driver 2 memorypositions.Note: Personal entry codes 3, 4 and 5 willnot recall memory positions.Erasing a Personal Code1. Enter the factory-set 5-digit code.2. Press and release 1·2 on the keypadwithin five seconds.3. Press and hold 1·2 for two seconds.You must do this within five secondsof completing Step 2.All personal codes will erase and only thefactory-set 5-digit code will work.Anti-Scan FeatureThe keypad will go into an anti-scan modeif you enter the wrong code seven times(35 consecutive button presses). Thismode disables the keypad for one minuteand the keypad lamp will flash.The anti-scan feature will turn off after:• One minute of keypad inactivity.• Pressing the unlock button on theremote control.• Switching the ignition on.Unlocking and Locking the DoorsTo Unlock the Driver DoorEnter the factory-set 5-digit code or yourpersonal code. You must press eachnumber within five seconds of each other.The interior lamps will illuminate.Note: All doors will unlock if you disablethe two-stage unlocking mode. SeeLocking and Unlocking (page 57).To Unlock All DoorsEnter the factory-set code or your personalcode, then press 3·4 within five seconds.To Lock All DoorsPress and hold 7·8 and 9·0 at the sametime (with the driver door closed). You donot need to enter the keypad code first.Displaying the Factory Set CodeNote: You will need to have twoprogrammed passive anti-theft keys for thisprocedure.To display the factory-set code in theinformation display:1. Insert a key into the ignition and switchthe ignition on for a few seconds.59F150 (TF6) , enUSA