8b7PW0

Universal Garage Door Opener (If Equipped)4. Press and hold both the programmedGenie button on the hand-heldtransmitter and the button you wantto program. The indicator light on thevisor will flash rapidly when theprogramming is successful.Note: The Genie transmitter will transmitfor up to 30 seconds. If HomeLink does notprogram within 30 seconds you will need topress the Genie transmitter again. If theGenie transmitter indicator light displaysgreen and red, release the button until theindicator light turns off before pressing thebutton again.Once you have programmed HomeLinksuccessfully, you must change the Genietransmitter out of program mode. To dothis:1. Press and hold the previouslyprogrammed Genie button on thehand-held transmitter for 10 seconds.The indicator light will change from redto red and green.2. Press the same button twice to confirmthe change. If done correctly theindicator light will turn green.Programming HomeLink to the GenieIntellicode Garage Door Opener MotorNote: You may need a ladder to access thegarage door opener motor.1. Press and hold the program button onthe garage door opener motor untilboth blue indicator lights turn on.2. Release the program button. Only thesmaller round indicator light should beon.3. Press and release the program button.The larger purple indicator light willflash.Note: The next two steps must becompleted in 30 seconds.4. Press and release the previouslyprogrammed button on the GenieIntellicode 2 hand-held transmitter.Both indicator lights on the garage dooropener motor unit should now flashpurple.5. Press and hold the previouslyprogrammed button on the visor fortwo seconds. Repeat this step up tothree times until the garage doormoves.Programming is now complete.Clearing a HomeLink DeviceTo erase programming from the threeHomeLink buttons press and hold the twoouter HomeLink buttons until the indicatorlight begins to flash. The indicator light willbegin flashing in 10-20 seconds. When thishappens, release both buttons. You havenow erased the programming, and theindicator light should blink slowly toindicate the device is in train mode whenyou press any of the three HomeLinkbuttons.E142662130F150 (TF6) , enUSA