8b7PW0

Security1. Insert the first previously programmedcoded key into the ignition.2. Switch the ignition from off to on. Keepthe ignition on for at least threeseconds, but no more than 10 seconds.3. Switch the ignition off and remove thefirst coded key from the ignition.4. After three seconds but within 10seconds of switching the ignition off,insert the second previously coded keyinto the ignition.5. Switch the ignition from off to on. Keepthe ignition on for at least threeseconds, but no more than 10 seconds.6. Switch the ignition off and remove thesecond previously programmed codedkey from the ignition.7. After three seconds but within 10seconds of switching the ignition offand removing the previouslyprogrammed coded key, insert the newunprogrammed key into the ignition.8. Switch the ignition from off to on. Keepthe ignition on for at least six secondsuntil you hear the door locks cycle.9. Remove the newly programmed codedkey from the ignition.The key will start the engine ifprogramming is successful. You canoperate the remote entry system if the newkey is an integrated keyhead transmitter.If programming was not successful, wait20 seconds and repeat Steps 1 through 8.If you are still unsuccessful, take yourvehicle to an authorized dealer.The direction indicators flash and the hornsounds if the system triggers while thealarm is armed.Take all remote controls to an authorizeddealer if there is any potential alarmproblem with your vehicle.Arming the AlarmThe alarm is ready to arm when there isnot a key in the ignition. Electronically lockthe vehicle to arm the alarm.The direction indicators flash once afteryou lock the vehicle. This indicates thealarm is in the pre-armed mode. It will fullyarm in 20 seconds.Disarming the AlarmDisarm the alarm by any of the followingactions:• Press the power door unlock buttonwithin the 20-second pre-armed mode.• Unlock the doors with the remotecontrol or keyless entry keypad.• Switch the ignition on or start thevehicle.• Use a key in the driver door to unlockthe vehicle, then switch the ignition onwithin 12 seconds.Note: Pressing the panic button on theremote control will stop the horn and signalindicators, but will not disarm the system.ANTI-THEFT ALARM (IF EQUIPPED)The system warns you of an unauthorizedentry to your vehicle. It triggers if any dooror the hood opens without using the key,remote control or keyless entry keypad.62F150 (TF6) , enUSA