8b7PW0

Keys and Remote ControlsIntegrated Keyhead Transmitter123Programming to the Transmitter1. With the ignition on, move the memoryfeatures to the desired positions usingthe associated controls.1E1630481. Twist a thin coin in the slot of thetransmitter near the key ring to removethe battery cover.2. Carefully peel up the rubber gasketfrom the transmitter. It may come offwith the battery cover.3. Remove the old battery4. Insert the new battery. Refer to theinstructions inside the transmitter forthe correct orientation of the battery.Press the battery down to make sureit is fully in the housing.5. Reinstall the rubber gasket.6. Snap the battery cover back onto thetransmitter.Memory Feature (If Equipped)You can use the remote control to recallmemory settings for the driver seat, powermirrors, steering column and power footpedals.Press the unlock button on the remotecontrol to recall the memory positions. Ifyou enable the easy-entry and exit feature,the seat will move to the easy-entryposition. The seat will move to the drivermemory position when you put the key inthe ignition.E16273422. Press and hold memory button 1 on theside of the driver seat. A tone will soundafter about two seconds. Continue tohold until you hear a second tone.3. Press the lock button on the remotecontrol within three seconds. A singletone sounds.Repeat this procedure with button 2 anda second remote control if desired.Deactivating from the Transmitter1. Press and hold the desired memorybutton for five seconds. A tone willsound after about two seconds.Continue to hold until you hear asecond tone.2. Press the unlock button on the remotecontrol within three seconds.Repeat this procedure for each additionaltransmitter if desired.Car FinderPress the button twice withinthree seconds. The horn willE138623sound and the turn signals willflash. We recommend you use this methodto locate your vehicle, rather than usingthe panic alarm.50F150 (TF6) , enUSA