8b7PW0

MyKey1. Insert the key you want to program intothe ignition.2. Switch the ignition on.3. Access the main menu on theinformation display controls. PressSETUP using the information displaybuttons until PRESS RESET TOCREATE MYKEY is displayed.4. Press and release the RESET button.You will see HOLD RESET TOCONFIRM MYKEY in the display.5. Press and hold the RESET button fortwo seconds until you see the messageMARK THIS AS RESTRICTED in thedisplay. Wait until you see KEYRESTRICTED AT NEXT START in thedisplay.If You Have a Type 2 InformationDisplay:1. Insert the key you want to program intothe ignition.2. Switch the ignition on.3. Access the main menu on theinformation display controls, and selectSETTINGS, then MYKEY by pressingOK or the > button.4. Press OK or the > button to selectCREATE A MYKEY.5. When prompted, hold the OK buttonuntil you see KEY RESTRICTED ATNEXT START in the display. The keywill be restricted at the next start.MyKey is successfully created. Make sureyou label it so you can distinguish it fromthe admin keys.You can also program configurablesettings for the key(s). Refer toProgramming/Changing ConfigurableSettings.Programming/ChangingConfigurable SettingsUse the information display to program orchange your configurable MyKey settings.There are two types of informationdisplays, and their controls and messagingvary. To determine which type of displayyou have, you will need to referenceanother chapter. See GeneralInformation (page 87).If You Have a Type 1 InformationDisplay:1. Switch the ignition on using an adminkey.2. Access the main menu on theinformation display controls, and pressSETUP until RESET FOR MYKEYSETTINGS displays.3. Press and release the RESET buttonto display MyKey setup menus.4. Press the SETUP button to enter yourchoice. Once you make a selection, thenext configurable setting will bedisplayed.5. Repeat Steps 3 and 4 until you aredone changing the configurablesettings.If You Have a Type 2 InformationDisplay:1. Switch the ignition on using an adminkey.2. Access the main menu on theinformation display controls, and selectSETTINGS, then MYKEY by pressingOK or the > button.3. Use the arrow buttons to get to aconfigurable feature.4. Press OK or > to make a selection.54F150 (TF6) , enUSA