Manual optoNCDT 1402 - Micro-Epsilon

Measurement Value Output7.2.2 Data Protocol ILD1402The digital measurement values are issued as unsigned digital values (raw values).Digital value Used for Digital value Used for0 ... 16367 Value range 16208 ... 16367 EMR back-up (1 %)0 ... 160 SMR back-up (1 %) 16370 ... 16383 Error codes161 ... 16207 Measurement rangeCalculation of a measurement value in mm from digital output:Reference value Start of Measuring Range:Reference value Midrange1.02x [mm] = (digital OUT *16368- 0.01) * MR [mm]x [mm] = (digital OUT *1.02- 0.51) * MR [mm]16368Example: MR =10 mm, digital value = 8184, measurement value = 5 mm or 0 mmNote: A digital value can be calculated from a measurement value (millimeter) as follows:x [mm]digitalOUT= + 0.01 *MR [mm]163681.02optoNCDT 14027.3 Digital Error CodesDigital error codes are issued in the same way as measurement values.Value range for error codes: 16370 ... 16384 (digital ) OUT--16370 no object detected--16372 too close to the sensor--16374 too far from the sensor--16376 target can not be evaluated--16378 external laser off--16380 target moves towards the sensor--16382 target moves away from sensor--16383 internal errorPage 39