Manual optoNCDT 1402 - Micro-Epsilon

Available Cables17. Available CablesiAll cables are cable carriers suitable.Type Cable length CharacteristicsPC1402- 3/I,PC1402-6/I,PC1402-8/IPC1402-3/U,PC1402-6/U,PC1402-8/UPC1402-3/U(01)PC1402-6/U(01)PC1402-3/USB/INDPC1402-3/CSP,PC1402-8/CSP,PC1402-10/CSPPC1402-3/IF2008,PC1402-6/IF2008,PC1402-8/IF20083 m6 m8 m3 m6 m8 m3 m6 m3 m3 m8 m10 m3 m6 m8 mPC1401/1402-0.2 0.2 m Patch cable, 12 pol to 7 pol.Interface und supply cable for current output, one end of thecable has a molded M12 female connector, the other end hasfree leads with ferrules.Interface und supply cable for voltage output (250 Ohm load,U = 1 … 5 V), one end of the cable has a molded M12 femaleoutconnector, the other end has free leads with ferrules.Interface und supply cable for voltage output (500 Ohm loadU = 2 … 10 V), 12 pol male connector on sensor side, openoutends on other side, cable carriers suitable,Power and output cable, one end of the cable has a moldedM12 female connector, the other end a 9 pol D-SUB for RS422/USB converter; a RS422/USB converter is not enclosed.Disconnect or connect the D-sub connection between RS422and USB converter when the sensor is disconnected from powersupply only.Connecting cable with straight connector on both sides to connectan ILD1402 sensor to a CSP2008.Connecting cable, one end of the cable has a molded M12female connector, the other end a D-SUB to connect an ILD1402sensor to an IF2008 PCI interface card.optoNCDT 1402Page 90