Manual optoNCDT 1402 - Micro-Epsilon

8.3.3 Reading the Sensor Parameters, INFO............................................................................................................ 458.3.4 Reading the Software Version, VERSION......................................................................................................... 468.3.5 Average On/Off, MEDIAN.................................................................................................................................. 468.3.6 Digital or Analog Data Output, OUTPUTCHANNEL......................................................................................... 478.3.7 Sensor Behavior in Error Case, SAVELASTMV................................................................................................ 488.3.8 Reset Sensor, BOOT......................................................................................................................................... 498.3.9 Changing Data Protocol, SET_CIMODE_1402 ................................................................................................ 498.3.10 Request Data Protocol, GET_CI_MODE........................................................................................................... 508.4 Data Protocol ILD1402...................................................................................................................................... 508.4.1 Setup of the Commands................................................................................................................................... 508.4.2 Communication without Error........................................................................................................................... 518.4.3 Communication with Error................................................................................................................................ 518.4.4 Overview............................................................................................................................................................ 528.4.5 Reading the Sensor Parameters, GET_INFO................................................................................................... 538.4.6 Reading the Sensor Settings, GET_SETTINGS............................................................................................... 558.4.7 Average Type and Average Number, SET_AV ................................................................................................. 598.4.8 Stopping the Measurement Value Output, DAT_OUT_OFF............................................................................. 608.4.9 Starting the Measurement Value Output, DAT_OUT_ON................................................................................. 608.4.10 Digital or Analog Data Output, SET_OUTPUT_CHANNEL .............................................................................. 618.4.11 Characteristics for Digital or Analog Data Output, SET_OUTPUTMODE ....................................................... 628.4.12 Set Output Time, SET_OUTPUTTIME_MS ...................................................................................................... 638.4.13 Error Output (Analog output), SET_ANALOG_ERROR_HANDLER ................................................................. 648.4.14 Set Baud Rate, SET_BAUDRATE ..................................................................................................................... 658.4.15 Set Measurement Rate, SET_SCANRATE ....................................................................................................... 668.4.16 Input for Scaling and Trigger, SET_EXT_INPUT_MODE ................................................................................. 678.4.17 Peak Detection with Video Signal, SET_PEAKSEARCHING ........................................................................... 688.4.18 Search Threshold, SET_THRESHOLD............................................................................................................. 698.4.19 Switching off the Laser (External), LASER_OFF............................................................................................... 708.4.20 Change Data Format, ASCII_OUTPUT............................................................................................................. 718.4.21 Key Lock, SET_KEYLOCK ................................................................................................................................ 728.4.22 Reset Sensor, RESET_BOOT............................................................................................................................ 738.4.23 Set Default Setting, SET_DEFAULT ................................................................................................................. 738.4.24 Save Settings in RAM or FLASH, SET_SAVE_SETTINGS_MODE................................................................... 758.4.25 Scaling Values for the Analog Output, SET_TEACH_VALUE........................................................................... 768.4.26 Reset Scaling Values for the Analog Output, RESET_TEACH_VALUE............................................................ 778.4.27 Changing Data Protocol, SET_CIMODE_1401................................................................................................. 788.4.28 Request Data Protocol, GET_CI_MODE........................................................................................................... 79optoNCDT 1402